Cleaning of EWIS Installed in the Rear Avionic Compartment (Only If Contaminated)(EWIS)
TASK 24-92-00-100-013-A
Cleaning of EWIS Installed in the Rear Avionic Compartment (Only If Contaminated)(EWIS)
1. Reason for the Job
Refer to the MPD TASK: 200127-02
CLEANING OF EWIS INSTALLED IN THE REAR AVIONIC COMPARTMENT (ONLY IF CONTAMINATED) (EWIS)
A. Fixtures, Tools, Test and Support Equipment
B. Work Zones and Access Panels
C. Referenced Information
3. Job Set-up
Subtask 24-92-00-010-108-B
Subtask 24-92-00-160-062-B
Subtask 24-92-00-410-106-B
[Rev.10 from 2021]
2026.03.31 23:27:11 UTC
Cleaning of EWIS Installed in the Rear Avionic Compartment (Only If Contaminated)(EWIS)
1. Reason for the Job
Refer to the MPD TASK: 200127-02
CLEANING OF EWIS INSTALLED IN THE REAR AVIONIC COMPARTMENT (ONLY IF CONTAMINATED) (EWIS)
NOTE: This is an EWIS (Electrical Wiring Interconnection System) procedure. EWIS is defined in ESPM 20-33-11.
2. Job Set-up InformationA. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | 1 | ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE |
| ZONE/ACCESS | ZONE DESCRIPTION |
|---|---|
| 127 | REAR AVIONIC COMPARTMENT |
| 128 | REAR AVIONIC COMPARTMENT |
| 824, 825 |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 24-41-00-862-002-A | De-energize the Aircraft Electrical Circuits Supplied from the External Power |
| TASK 24-41-00-862-002-A-01 | De-energize the Aircraft Electrical Circuits Supplied from the APU |
| TASK 24-41-00-862-002-A-02 | De-energize the Aircraft Electrical Circuits Supplied from the Engine 1(2) |
| TASK 25-54-11-000-001-A | Removal of the Forward Cargo-Compartment Partition FR24A |
| TASK 25-54-11-400-001-A | Installation of the Forward Cargo-Compartment Partition FR24A |
| TASK 52-30-00-860-001-A | Open the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump |
| TASK 52-30-00-860-002-A | Close the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump |
| TASK 52-30-00-860-003-A | Open the FWD or Aft Cargo-Compartment Door with the Hand Pump |
| TASK 52-30-00-860-004-A | Close the FWD or Aft Cargo-Compartment Door with the Hand Pump |
| TASK 52-41-00-010-002-A | Open the Avionics Compartment Doors for Access |
| TASK 52-41-00-410-002-A | Close the Avionics Compartment Doors after Access |
| TASK 53-12-13-000-001-A | Removal of the avionics compartment floor panels |
| TASK 53-12-13-400-001-A | Installation of the avionics compartment floor panels |
| ESPM 2055000 | |
| TASK 06-41-53-00 | FUSELAGE-DESCRIPTION AND OPERATION |
Subtask 24-92-00-010-108-B
A. Get Access
(1) Put an ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE in position.
(2) Open the access door 824 (Ref. AMM TASK 52-41-00-010-002).
(3) Open the forward cargo-compartment door 825 (Ref. AMM TASK 52-30-00-860-001) or (Ref. AMM TASK 52-30-00-860-003).
(4) Remove the aft avionic-compartment floor-panels between FR21 and FR24 (Ref. AMM TASK 53-12-13-000-001) and (Ref. AMM D/O 06-41-53-00).
(5) Remove the forward cargo-compartment partition-panels at FR24A (Ref. AMM TASK 25-54-11-000-001) and (Ref. AMM D/O 06-41-53-00).
Subtask 24-92-00-862-096-B 4. Procedure(1) Put an ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE in position.
(2) Open the access door 824 (Ref. AMM TASK 52-41-00-010-002).
(3) Open the forward cargo-compartment door 825 (Ref. AMM TASK 52-30-00-860-001) or (Ref. AMM TASK 52-30-00-860-003).
(4) Remove the aft avionic-compartment floor-panels between FR21 and FR24 (Ref. AMM TASK 53-12-13-000-001) and (Ref. AMM D/O 06-41-53-00).
(5) Remove the forward cargo-compartment partition-panels at FR24A (Ref. AMM TASK 25-54-11-000-001) and (Ref. AMM D/O 06-41-53-00).
Subtask 24-92-00-160-062-B
A. Cleaning of All Wiring Installed in the Rear Avionic Compartment (Only Contaminated Wiring)
(1) Clean the wiring if there is dust, lint or hydraulic contamination ESPM 2055000.
(a) On the AC/DC feeder routes: 1G and 2G.
(b) On the AC/DC power-distribution routes: 1P and 2P.
(c) On the flight control wiring.
(d) On the engine control routes: 1S and 2S.
(e) On the other routes: 1M and 2M.
(f) On the audio route: 1R.
(g) On the coaxial wiring routes: 3T and 4T.
(h) On the generator excitation routes: 1E and 2E.
5. Close-up(1) Clean the wiring if there is dust, lint or hydraulic contamination ESPM 2055000.
(a) On the AC/DC feeder routes: 1G and 2G.
(b) On the AC/DC power-distribution routes: 1P and 2P.
(c) On the flight control wiring.
(d) On the engine control routes: 1S and 2S.
(e) On the other routes: 1M and 2M.
(f) On the audio route: 1R.
(g) On the coaxial wiring routes: 3T and 4T.
(h) On the generator excitation routes: 1E and 2E.
Subtask 24-92-00-410-106-B
A. Close Access
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Install the aft avionic-compartment floor-panels between FR21 and FR24 (Ref. AMM TASK 53-12-13-400-001) and (Ref. AMM D/O 06-41-53-00).
(3) Install the forward cargo-compartment partition-panels at FR24A (Ref. AMM TASK 25-54-11-400-001) and (Ref. AMM D/O 06-41-53-00).
(4) Close the forward cargo-compartment door 825 (Ref. AMM TASK 52-30-00-860-002) or (Ref. AMM TASK 52-30-00-860-004).
(5) Close the access door 824 (Ref. AMM TASK 52-41-00-410-002).
(6) Remove the access platform(s).
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Install the aft avionic-compartment floor-panels between FR21 and FR24 (Ref. AMM TASK 53-12-13-400-001) and (Ref. AMM D/O 06-41-53-00).
(3) Install the forward cargo-compartment partition-panels at FR24A (Ref. AMM TASK 25-54-11-400-001) and (Ref. AMM D/O 06-41-53-00).
(4) Close the forward cargo-compartment door 825 (Ref. AMM TASK 52-30-00-860-002) or (Ref. AMM TASK 52-30-00-860-004).
(5) Close the access door 824 (Ref. AMM TASK 52-41-00-410-002).
(6) Remove the access platform(s).
Rear Avionic Compartment