Removal of the Air Intake Nose (APS 3200)

TASK 49-16-44-000-002-A
Removal of the Air Intake Nose (APS 3200)

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 4M (13 FT)-ADJUSTABLE
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
315AL, 316AR

C. Referenced Information

REFERENCE	DESIGNATION
TASK 24-41-00-861-002-A	Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01	Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02	Energize the Aircraft Electrical Circuits from Engine 1(2)
TASK 29-14-00-614-001-A	Depressurization of the Hydraulic Reservoirs
TASK 52-41-00-010-001-A	Open the APU Doors for Access
Air Intake Nose

3. Job Set-up
Subtask 49-16-44-860-054-A ** ON A/C NOT FOR ALL

A. Aircraft Maintenance Configuration
(1) Energize the ground service network
(Ref. AMM TASK 24-41-00-861-002).
(2) On the panel 25VU, put the APU Master Switch to the ON position.
(3) Put a warning notice in the cockpit to tell persons not to start the APU.
(4) Make sure that the hydraulic systems are depressurized
(Ref. AMM TASK 29-14-00-614-001).

Subtask 49-16-44-865-053-A ** ON A/C NOT FOR ALL

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
121VU	APU/APU/CTL	2KD	L42
121VU	APU/ECB/SPLY	1KD	L41

Subtask 49-16-44-010-051-A ** ON A/C NOT FOR ALL

C. Get Access
(1) Put the ACCESS PLATFORM 4M (13 FT)-ADJUSTABLE in position below the APU compartment.
(2) Open the APU access doors 315AL 316AR (Ref. AMM TASK 52-41-00-010-001).

4. Procedure
Subtask 49-16-44-020-051-A ** ON A/C NOT FOR ALL

A. Removal of the Air Intake Nose
(1) Remove the screws (7 and 8), the washers (6 and 9), the end-profile (5) and the bracket (4).
(2) Remove the screws (1).
(3) Remove the bolts (10), the washers (11) and the nuts (12).
(4) Remove the screws (3) and the washers (2).
(5) Remove the air intake nose (13) from the air inlet duct (14).

[Rev.10 from 2021] 2026.04.01 12:42:32 UTC