W DOC AIRBUS | AMM A320F

Removal of the Toilet Bowl


TASK 38-31-42-000-001-A
Removal of the Toilet Bowl


WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.
WARNING: DO NOT DO WORK ON THE TOILET WASTE SYSTEM AND THE POTABLE WATER SYSTEM AT THE SAME TIME. THIS WILL PREVENT CONTAMINATION OF THE POTABLE WATER SYSTEM. SUCH CONTAMINATION CAN BE DANGEROUS TO HEALTH.
WARNING: ALWAYS USE RUBBER GLOVES WHEN YOU DO WORK:
  • ON THE TOILET WASTE SYSTEM, OR
  • ON PARTS THAT HAVE CONTAMINATION FROM THE WASTE SYSTEM.
WHEN YOU COMPLETE THE WORK PROCEDURE, CLEAN YOUR HANDS WITH SOAP AND WATER. THIS WILL PREVENT INFECTION (TOILET WASTE IS DANGEROUS FOR HEALTH).
WARNING: WHEN YOU REMOVE A COMPONENT OF THE TOILET WASTE SYSTEM, ALWAYS DISINFECT THE PART BEFORE YOU PUT IT IN A PLASTIC BAG, THEN SEAL THE BAG. DO NOT PUT DOCUMENTS INTO THE PLASTIC BAG. SEAL THE BAG FIRST,THEN ATTACH THE DOCUMENTS TO IT. THIS WILL PREVENT INFECTION OR ILLNESS. CONTAMINATION FROM THE WASTE CAN BE DANGEROUS TO HEALTH.
NOTE: The procedure for the removal of all the toilet bowls is the same.
1. Reason for the Job
Self explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
AR
PLUG - BLANKING
No specific
AR
SAFETY CLIP - CIRCUIT BREAKER
No specific
AR
WARNING NOTICE(S)
 B. Consumable Materials
REFERENCE
DESIGNATION
(Material No.11CBA1)
Disinfectant and cleaner-Aircraft general - -
 C. Referenced Information
REFERENCE
DESIGNATION
TASK 24-42-00-861-001-A
Energize the Ground Service Network from the External Power
TASK 25-45-22-000-001-A
Removal of the Toilet Shroud and the Seat
TASK 25-45-22-000-802-A
Removal of the Toilet Shroud of the Space Flex Lavatory
TASK 38-10-00-614-002-A
Depressurization of the Potable Water System
TASK 38-30-00-510-001-A
Decontamination of Components of the Waste/Water and Toilet System for Shipping and/or Installation
TASK 38-31-00-680-001-A
Draining of the Toilet System
TASK 38-31-56-000-001-A
Removal of the Anti-Syphon Valve
TASK 38-31-66-000-801-A
Removal of the Flush Ring
F Toilet Bowl ** ON A/C NOT FOR ALL
F Toilet Bowl ** ON A/C NOT FOR ALL
3. Job Set-up
Subtask 38-31-42-861-050-A ** ON A/C NOT FOR ALL
A. Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).
Subtask 38-31-42-680-050-A ** ON A/C NOT FOR ALL
B. Drain the toilet system (Ref. AMM TASK 38-31-00-680-001).
Subtask 38-31-42-865-059-A ** ON A/C NOT FOR ALL
C. Open, safety and tag this(these) circuit breaker(s):
PANELDESIGNATIONFINLOCATION
** ON A/C NOT FOR ALL
2001VUVACU TOIL SYS-VACUUM-GEN33MGA08
** ON A/C NOT FOR ALL
2001VUVACU TOIL SYS-LAV PWR-E34MGA04
2001VUVACU TOIL SYS-LAV PWR-D39MGA03
** ON A/C NOT FOR ALL
2001VUVACU TOIL SYS-VACU-SYS35MGA06
2001VUVACU TOIL SYS-LAV PWR-A32MGA01
** ON A/C NOT FOR ALL
2001VUVACU TOIL SYS-VACU-GEN33MGA08
** ON A/C NOT FOR ALL
2001VUVACU TOIL SYS-LAV PWR-G34MGA04
2001VUVACU TOIL SYS-LAV PWR-F39MGA03
2001VUVACU TOIL SYS-LAV PWR-D45MGA02
Subtask 38-31-42-010-051-A ** ON A/C NOT FOR ALL
D. Get Access
   (1) Make sure that the potable water system is depressurized (Ref. AMM TASK 38-10-00-614-002).
   (2) Open the lavatory door.
   (3) Open the sanitary cabinet door.
   (4) Close the potable-water shutoff valve.
   (5) Put the WARNING NOTICE(S) in position to tell persons not to open the potable-water shutoff valve.
   (6) Remove the toilet shroud (Ref. AMM TASK 25-45-22-000-001) (Ref. AMM TASK 25-45-22-000-802).
   (7) Disinfect the toilet assembly with Disinfectant and cleaner-Aircraft general - - (Material No.11CBA1) .
4. Procedure
Subtask 38-31-42-020-050-B ** ON A/C NOT FOR ALL
A. Removal of the Toilet Bowl
F Toilet Bowl ** ON A/C NOT FOR ALL
F Toilet Bowl ** ON A/C NOT FOR ALL
WARNING: ALWAYS WEAR RUBBER GLOVES, GOGGLES AND PROTECTIVE CLOTHES WHEN YOU DO THIS TASK.
   (1) Remove the flush ring (Ref. AMM TASK 38-31-66-000-801).
   (2) Remove the Anti-syphon valve (Ref. AMM TASK 38-31-56-000-001).
   (3) Disconnect the inlet elbow (4) from the toilet bowl (1):
     (a) Push the locking pins (3) in.
     (b) Pull the cam levers (2) out.
     (c) Disconnect the inlet elbow (4).
     (d) Put the PLUG-BLANKING in each disconnected line end.
   (4) Remove the toilet bowl (1) from the toilet assembly.
   (5) If you use removed parts again, clean and disinfect them (Ref. AMM TASK 38-30-00-510-001).
[Rev.10 from 2021] 2026.04.01 01:20:27 UTC