Remove Nose Landing Gear for Special Detailed Inspection in Shop

TASK 32-21-00-200-802-A
Remove Nose Landing Gear for Special Detailed Inspection in Shop

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

WARNING: MAKE SURE THAT THE TRAVEL RANGES OF THE LANDING GEAR ARE CLEAR.

ZONE: 710

1. Reason for the Job
Refer to the MPD TASK: 322111-01
REMOVE NOSE LANDING GEAR FOR SPECIAL DETAILED INSPECTION IN SHOP
You must do this task as per the related CMM.
2. Job Set-up Information
A. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
710	NOSE GEAR AND DOORS

B. Referenced Information

REFERENCE	DESIGNATION
TASK 32-21-11-000-003-A	Removal of the NLG Leg Assembly
TASK 32-21-11-400-003-A	Installation of the NLG Leg Assembly
TASK 32-21-16-000-002-A	Removal of the NLG Drag-Strut Assy
TASK 32-21-16-000-002-A-02	Removal of the Nose Landing Gear (NLG) Drag-Strut Assy (EV NLG)
TASK 32-21-16-400-002-A	Installation of the NLG Drag-Strut Assy
TASK 32-21-16-400-002-A-02	Installation of the Nose Landing Gear (NLG) Drag-Strut Assy (EV NLG)

3. Job Set-up
Subtask 32-21-00-020-053-A

A. Removal before Inspection
(1) Remove the NLG leg assembly (Ref. AMM TASK 32-21-11-000-003).

NOTE: When you remove the NLG leg assembly, it is not necessary to remove all the Line Replaceable Units (LRUs). Refer to MPD Appendix 7 for these LRUs.

(2) Remove the NLG drag-strut assembly (Ref. AMM TASK 32-21-16-000-002).

4. Procedure
Subtask 32-21-00-220-069-A

A. Special Detailed Inspection (Overhaul) of Nose Gear (Off Aircraft)

Refer to MPD Appendix 7.

5. Close-up
Subtask 32-21-00-420-053-A

A. Installation after Inspection
(1) Install the NLG drag-strut assembly (Ref. AMM TASK 32-21-16-400-002).
(2) Install the NLG leg assembly (Ref. AMM TASK 32-21-11-400-003).

[Rev.10 from 2021] 2026.04.01 00:41:48 UTC