W DOC AIRBUS | AMM A320F

Removal of the Center Ceiling Stowage-Compartment

TASK 25-24-50-000-801-A
Removal of the Center Ceiling Stowage-Compartment

WARNING: BE CAREFUL WHEN YOU REMOVE OR INSTALL THIS EQUIPMENT. THIS EQUIPMENT IS HEAVY (MORE THAN 12 KG (26.5 lb)) AND CAN CAUSE INJURY AND/OR DAMAGE.
ZONE: 200
1. Reason for the Job
NOTE: More than one person is necessary for this procedure.
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
AR
CAP - BLANKING
No specific
AR
SAFETY CLIP - CIRCUIT BREAKER
No specific
AR
SCRAPER - WOODEN
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
200
UPPER HALF FUSELAGE
 C. Expendable Parts
FIG.ITEM
DESIGNATION
IPC-CSN
21
COTTER PINS
AIPC 25-24-89-95-050
 D. Referenced Information
REFERENCE
DESIGNATION
TASK 24-41-00-861-002-A
Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01
Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02
Energize the Aircraft Electrical Circuits from Engine 1(2)
TASK 25-23-41-000-001-A
Removal of the Ceiling Panels
TASK 33-51-11-000-001-A
Removal of the Cabin Emergency Lights
F Center Ceiling Stowage-Compartment
3. Job Set-up
Subtask 25-24-50-860-050-A
A. Aircraft Maintenance Configuration
   (1) Energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-861-002).
Subtask 25-24-50-010-050-A
B. Get Access
F Center Ceiling Stowage-Compartment
   (1) Remove the emergency light (Ref. AMM TASK 33-51-11-000-001).
   (2) Remove all items of equipment from the center ceiling stowage-compartment (4).
Subtask 25-24-50-865-050-A
C. Open, safety and tag this(these) circuit breaker(s):
PANELDESIGNATIONFINLOCATION
** ON A/C ALL
49VULIGHTING/EMER LT/CABIN2WLH04
122VULIGHTING/CABIN/EMER/LT3WLV07
2000VUCAB LIGHT PWR-CEILING-AFT307LGH08
2000VUCAB LIGHT PWR-CEILING-AFT304LGH07
2001VULAVATORY AFT-OCCUPIED11WJB04
4. Procedure
Subtask 25-24-50-020-050-B
A. Removal of the Center Ceiling Stowage-Compartment
F Center Ceiling Stowage-Compartment
WARNING: YOU MUST MAKE SURE THAT YOU CAN HOLD THE COMPONENT BEFORE YOU REMOVE/INSTALL IT. THE COMPONENT IS HEAVY. IF IT FALLS, IT CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
   (1) Make match marks on the components that you disconnect/remove to record their connections/positions. This is important for the subsequent installation procedure.
   (2) Open the bins of the adjacent overhead stowage compartments (OHSC).
   (3) Push the fasteners (13) with a SCRAPER - WOODEN and open the access doors (12) in the OHSCs.
   (4) Disconnect the electrical connectors (14).
   (5) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
   (6) Push the ceiling panels (16) up to release the pins (17). Pull the ceiling panels (16) down to release the ceiling panels (16) from the latches (15) and remove the ceiling panels (16).
   (7) Remove the adjacent ceiling panels (Ref. AMM TASK 25-23-41-000-001).
   (8) Open the center-ceiling stowage-compartment door (3) as follows:
NOTE: The center-ceiling stowage-compartment door (3) locks at the 40-degree position.
     (a) Fully open the center-ceiling stowage-compartment door (3).
WARNING: USE PROTECTIVE GOGGLES WHEN YOU REMOVE OR INSTALL A COTTER PIN. EACH TIME YOU REMOVE A COTTER PIN DURING THE TASK, DISCARD IT IMMEDIATELY. A LOOSE COTTER PIN CAN CUT YOU OR MAKE YOU BLIND.
     (b) Remove and discard the cotter pins (21) from the bolts (20).
     (c) Remove the washers (22) and disengage the dampers (23) from the center-ceiling stowage-compartment door (3).
     (d) Open the center-ceiling stowage-compartment door (3) accurately at the 70-degree position.
NOTE: The override ceiling stowage flap must not be more than 70-degree.
     (e) Release the quick-release pins (18) from the dampers (19).
   (9) Remove the screws (2) and the covers (1).
   (10) Disconnect the electrical connectors (5).
   (11) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
   (12) Close the center-ceiling stowage-compartment door (3) as follows:
     (a) Put the dampers (19) in position and install the quick-release pins (18).
     (b) Engage the dampers (23) to the bolts (20) on the center-ceiling stowage-compartment door (3).
WARNING: USE PROTECTIVE GOGGLES WHEN YOU REMOVE OR INSTALL A COTTER PIN. EACH TIME YOU REMOVE A COTTER PIN DURING THE TASK, DISCARD IT IMMEDIATELY. A LOOSE COTTER PIN CAN CUT YOU OR MAKE YOU BLIND.
     (c) Install the washers (22) on the bolts (20) and safety the bolts (20) with the new AIPC 25-24-89-95-050 COTTER PINS (21).
     (d) Close the center-ceiling stowage-compartment door (3).
   (13) Hold the center ceiling stowage-compartment (4) and remove the clips (11) to release tie rods (10).
   (14) Remove the quick-release pins (8) to release the tie rods (9).
   (15) Remove the quick-release pins (6) to release the tie rods (7).
   (16) Carefully remove the center ceiling stowage-compartment (4).
[Rev.10 from 2021] 2026.03.31 23:32:17 UTC
"Aviabrain" 2025