DOC AIRBUS | AMM A320FRemoval of the Throttle Control Artificial Feel Unit [CFMI]
TASK 76-11-17-000-040-A
Removal of the Throttle Control Artificial Feel Unit
1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Work Zones and Access Panels
C. Referenced Information
3. Job Set-up
Subtask 76-11-17-865-050-A ** ON A/C NOT FOR ALL
Subtask 76-11-17-480-054-A ** ON A/C NOT FOR ALL Subtask 76-11-17-020-050-A ** ON A/C NOT FOR ALL
[Rev.10 from 2021]
2026.04.01 03:15:15 UTC
Removal of the Throttle Control Artificial Feel Unit
1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | AR | ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE |
| No specific | AR | CAP - BLANKING |
| No specific | AR | SAFETY CLIP - CIRCUIT BREAKER |
| No specific | AR | WARNING NOTICE(S) |
| 98DNSA20206080 | 1 | RIGGING PIN |
| ZONE/ACCESS | ZONE DESCRIPTION |
|---|---|
| 811 |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 22-82-12-000-001-A | Removal of the Multipurpose Control & Display Unit (MCDU) |
| TASK 23-13-13-000-001-A | Removal of the Radio Management Panel (RMP) |
| TASK 23-51-12-000-001-A | Removal of the Audio Control Panel (ACP) |
| TASK 34-41-12-000-001-A | Removal of the Weather-Radar Control Unit |
| TASK 34-52-12-000-001-A | Removal of the ATC/TCAS Control Unit |
Panels 111 and 112VUSubtask 76-11-17-865-050-A ** ON A/C NOT FOR ALL
A. Open, safety and tag this(these) circuit breaker(s):
Subtask 76-11-17-869-050-A ** ON A/C NOT FOR ALL | PANEL | DESIGNATION | FIN | LOCATION |
|---|---|---|---|
| ** ON A/C NOT FOR ALL | |||
| 49VU | ENGINE/1 AND 2/IGN/SYS A | 1JH | A03 |
| 49VU | FLIGHT CONTROLS/SEC1/NORM/SPLY | 21CE1 | B08 |
| 49VU | LIGHTING/EMER LT/CKPT/DOME | 1LE | H08 |
| 105VU | FLT CTL/SEC1/STBY SPLY | 22CE | B01 |
| 121VU | ENGINE/IGN/ENG2/SYS B | 3JH2 | P42 |
| 121VU | ENGINE/IGN/ENG1/SYS B | 3JH1 | P41 |
| 121VU | ENGINE/IGN/ENG2/SYS A BAT | 2JH2 | P40 |
| 121VU | ENGINE/IGN/ENG1/SYS A BAT | 2JH1 | P39 |
| 121VU | FLIGHT CONTROLS/SEC3/SPLY | 21CE3 | Q19 |
| 121VU | FLIGHT CONTROLS/SEC2/SPLY | 21CE2 | Q18 |
| 122VU | LIGHTING/INSTL LT/MAIN INST/PNL AND/PED | 4LF | Y04 |
| 122VU | LIGHTING/FLOOD/CTR INST/PNL | 2LE | Z04 |
B. Make sure that the throttle control levers are at idle (0 degree).
Subtask 76-11-17-941-050-A ** ON A/C NOT FOR ALL C. Safety Precautions
(1) Put a WARNING NOTICE(S) in the cockpit to tell persons not to move:
Subtask 76-11-17-010-050-A ** ON A/C NOT FOR ALL Subtask 76-11-17-010-051-A ** ON A/C NOT FOR ALL (1) Put a WARNING NOTICE(S) in the cockpit to tell persons not to move:
- the throttle control levers
- the slat and flap control levers.
- Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
- Install a WARNING NOTICE(S).
- Put a WARNING NOTICE(S) to tell persons not to start the engine 1(2).
E. Get Access
(1) Remove the Multipurpose Control and Display Units 3CA1 and 3CA2 (Ref. AMM TASK 22-82-12-000-001).
(2) Remove the Radio Management Panels 1RG1 and 1RG2 (Ref. AMM TASK 23-13-13-000-001).
(3) Remove the Audio Control Panels 2RN1 and 2RN2 (Ref. AMM TASK 23-51-12-000-001).
(4) Remove the Weather Radar Control Unit 3SQ (Ref. AMM TASK 34-41-12-000-001).
(5) Remove the ATC/TCAS Control Unit 3SH (Ref. AMM TASK 34-52-12-000-001).
(6) Remove the FLOOD LT/INTEG LT panel 111VU and FLOOD LT panel 112VU:
(b) Disconnect the connector (3) from the panel (1).
(c) Remove the panel (1).
(d) Put CAP - BLANKING on the connectors (2) and (3).
(7) Remove the screws (7).
(8) Remove the ventilation plates (8).
(9) Disconnect the clamps (9).
(10) Remove the screws (6) and the washers (5).
(11) Remove the plates (4) and (10).
4. Procedure(1) Remove the Multipurpose Control and Display Units 3CA1 and 3CA2 (Ref. AMM TASK 22-82-12-000-001).
(2) Remove the Radio Management Panels 1RG1 and 1RG2 (Ref. AMM TASK 23-13-13-000-001).
(3) Remove the Audio Control Panels 2RN1 and 2RN2 (Ref. AMM TASK 23-51-12-000-001).
(4) Remove the Weather Radar Control Unit 3SQ (Ref. AMM TASK 34-41-12-000-001).
(5) Remove the ATC/TCAS Control Unit 3SH (Ref. AMM TASK 34-52-12-000-001).
(6) Remove the FLOOD LT/INTEG LT panel 111VU and FLOOD LT panel 112VU:
NOTE: The removal procedure is the same for the FLOOD LT/INTEG panel 111VU and FLOOD LT panel 112VU.
(a) Release the fasteners of the panel (1) and disengage the panel (1) from its housing. (b) Disconnect the connector (3) from the panel (1).
(c) Remove the panel (1).
(d) Put CAP - BLANKING on the connectors (2) and (3).
(7) Remove the screws (7).
(8) Remove the ventilation plates (8).
(9) Disconnect the clamps (9).
(10) Remove the screws (6) and the washers (5).
(11) Remove the plates (4) and (10).
Subtask 76-11-17-480-054-A ** ON A/C NOT FOR ALL Subtask 76-11-17-020-050-A ** ON A/C NOT FOR ALL
B. Remove the Throttle Control Artificial Feel Unit as follows:
(1) Remove and discard the 4 cotter pins (13)
(2) Remove the 4 nuts (14), the 4 washers (15) and the 4 bolts (17). Make sure that the 4 bushes (16) stay bonded.
(3) Remove the rods (27).
(4) Remove and discard the 4 cotter pins (18).
(5) Remove the 2 nuts (19), the 2 washers (20) and the 2 bolts (26). Make sure that the 2 bushes (25) stay bonded.
(6) Remove the 2 nuts (21), the 2 washers (22) and the 2 bolts (24).
(7) Remove the throttle control artificial feel unit (23).
(1) Remove and discard the 4 cotter pins (13)
(2) Remove the 4 nuts (14), the 4 washers (15) and the 4 bolts (17). Make sure that the 4 bushes (16) stay bonded.
(3) Remove the rods (27).
(4) Remove and discard the 4 cotter pins (18).
(5) Remove the 2 nuts (19), the 2 washers (20) and the 2 bolts (26). Make sure that the 2 bushes (25) stay bonded.
(6) Remove the 2 nuts (21), the 2 washers (22) and the 2 bolts (24).
(7) Remove the throttle control artificial feel unit (23).