Removal of the Audio Control Panel (ACP)
TASK 23-51-12-000-001-A
Removal of the Audio Control Panel (ACP)
1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Work Zones and Access Panels
C. Referenced Information
3. Job Set-up
Subtask 23-51-12-865-050-A
Subtask 23-51-12-020-050-A
[Rev.10 from 2021]
2026.04.01 04:40:00 UTC
Removal of the Audio Control Panel (ACP)
1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | AR | CAP - BLANKING |
| No specific | AR | SAFETY CLIP - CIRCUIT BREAKER |
| ZONE/ACCESS | ZONE DESCRIPTION |
|---|---|
| 120 | AVIONICS COMPARTMENT |
| 128 | REAR AVIONIC COMPARTMENT |
| 210 | CKPT,FWD COMPT BHD TO FLT COMPT BULKHEAD |
| 211 | COCKPIT |
| REFERENCE | DESIGNATION |
|---|---|
Subtask 23-51-12-865-050-A
A. Open, safety and tag this(these) circuit breaker(s):
4. Procedure| PANEL | DESIGNATION | FIN | LOCATION |
|---|---|---|---|
| ** ON A/C NOT FOR ALL | |||
| 49VU | LIGHTING/XFMR/115V.5V/ESS BUS | 29LP | H03 |
| ** ON A/C NOT FOR ALL | |||
| 49VU | COM/AUDIO/ACP/F/O | 5RN | G07 |
| ** ON A/C NOT FOR ALL | |||
| 49VU | COM/AUDIO/ACP/CAPT | 4RN | G06 |
| ** ON A/C NOT FOR ALL | |||
| 49VU | COM/ACP F/O/BITE/ INT 2 AUDIO/3&5 OCCPNT | 5RN | G07 |
| ** ON A/C NOT FOR ALL | |||
| 49VU | COM/ACP CAPT/SELCAL/INT 1 AUDIO/AVNCS | 4RN | G06 |
| ** ON A/C NOT FOR ALL | |||
| 49VU | LIGHTING/XFMR/115V.5V/ESS BUS | 29LP | H01 |
| ** ON A/C ALL | |||
| 121VU | COM NAV/ACP/THIRD/OCCPNT | 6RN | M02 |
| ** ON A/C NOT FOR ALL | |||
| 121VU | COM NAV/ACP/FOURTH/OCCPNT | 20RN | M01 |
| ** ON A/C ALL | |||
| 122VU | LIGHTING/ANN LT SPLY/XFMR/BUS 2 | 27LP | X05 |
| 122VU | LIGHTING/ANN LT SPLY/XFMR/BUS 1 | 26LP | X04 |
| 122VU | LIGHTING/ANN LT SPLY/XFMR/STAT INV | 28LP | X03 |
| 122VU | LIGHTING/INSTL LT/MAIN INST/PNL AND/PED | 4LF | Y04 |
| 122VU | LIGHTING/INSTL LT/OVHD/PNL | 3LF | Y03 |
Subtask 23-51-12-020-050-A
A. Removal of the Audio Control Panel
(2) Pull the audio control panel (2) from its housing.
(3) Disconnect the electrical connector (4) from the receptacle (3).
(4) Remove the audio control panel (2).
(5) Put CAP - BLANKING on the electrical connector (4) and the receptacle (3).
NOTE: This removal procedure is applicable to each audio control panel.
(1) Loosen the Dzus fasteners (1) by a quarter turn. (2) Pull the audio control panel (2) from its housing.
(3) Disconnect the electrical connector (4) from the receptacle (3).
(4) Remove the audio control panel (2).
(5) Put CAP - BLANKING on the electrical connector (4) and the receptacle (3).
Audio Control Panel (ACP)