Removal of the Reservoir Drain Valve

TASK 29-12-35-000-001-A
Removal of the Reservoir Drain Valve

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

FIN: 2264GM

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	CONTAINER - HYDRAULIC FLUID RESISTANT
No specific	2	PLUG - BLANKING
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	2	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
197EB

C. Referenced Information

REFERENCE	DESIGNATION
TASK 29-00-00-864-001-A	Put the Related Hydraulic System in the Depressurized Configuration before Maintenance Action
TASK 29-00-00-910-002-A	Safety Procedures of the Hydraulic System
TASK 29-10-00-680-003-A	Drainage of the Reservoir of the Blue Hydraulic System
TASK 29-14-00-614-001-A	Depressurization of the Hydraulic Reservoirs
Reservoir Drain Valve

3. Job Set-up
Subtask 29-12-35-865-050-A

A. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
49VU	HYD/HYD PWR/B WARN/& CTL	2702GJ	C12
123VU	B HYD/ELEC PUMP	2701GJ	AB09

Subtask 29-12-35-860-050-A

B. Aircraft Maintenance Configuration

WARNING: OBEY THE HYDRAULIC SAFETY PROCEDURES.

(1) Obey the hydraulic safety procedures (Ref. AMM TASK 29-00-00-910-002).
(2) Put WARNING NOTICE(S) in position to tell persons not to pressurize the Blue hydraulic system:

in the cockpit on the hydraulic section 40VU of the overhead panel,
on the ground service panel of the Blue hydraulic system.

(3) Make sure that the Blue hydraulic system is depressurized and put it in the maintenance configuration.
(Ref. AMM TASK 29-00-00-864-001).
(4) Depressurize the reservoir of the Blue hydraulic system (Ref. AMM TASK 29-14-00-614-001).
(5) Drain the reservoir of the Blue hydraulic system (Ref. AMM TASK 29-10-00-680-003).
(6) Put a CONTAINER - HYDRAULIC FLUID RESISTANT below the drain valve (2264GM).

Subtask 29-12-35-010-050-A

C. Open the access door 197EB.

4. Procedure
Subtask 29-12-35-020-050-A

A. Removal of the Reservoir Drain Valve
(1) Remove and discard the lockwire from the reservoir drain valve (1).
(2) Remove the reservoir drain valve (1) from the adaptor (3).
(3) Remove and discard the O-ring (2).
(4) Install a PLUG - BLANKING on the adaptor (3) and the reservoir drain valve (1).

[Rev.10 from 2021] 2026.04.01 07:53:17 UTC