Removal of the Access Panel
TASK 57-41-37-000-010-A
Removal of the Access Panel
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Work Zones and Access Panels
C. Referenced Information
3. Job Set-up
Subtask 57-41-37-941-074-A
Subtask 57-41-37-020-061-A
[Rev.10 from 2021]
2026.04.01 03:53:11 UTC
Removal of the Access Panel
WARNING:
PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:
1. Reason for the Job- THE FLIGHT CONTROLS
- THE FLIGHT CONTROL SURFACES
- THE LANDING GEAR AND THE RELATED DOORS
- COMPONENTS THAT MOVE.
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | AR | ACCESS PLATFORM 4M (13 FT)-ADJUSTABLE |
| No specific | AR | SAFETY BARRIER(S) |
| No specific | AR | SAFETY CLIP - CIRCUIT BREAKER |
| No specific | AR | WARNING NOTICE(S) |
| ZONE/ACCESS | ZONE DESCRIPTION |
|---|---|
| 521 | INBOARD FIXED L.E STRUCTURE |
| 621 | INBOARD FIXED L.E STRUCTURE |
| 472AR, 481AL |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 27-80-00-866-004-A | Extending the Slats on the Ground |
| TASK 54-53-11-000-804-A | Removal of the Pylon-to-Wing Access Panels and Doors |
Subtask 57-41-37-941-074-A
A. Safety Precautions
(1) As necessary, use the applicable SAFETY BARRIERS, specified by the operator's instructions and your local regulations.
Subtask 57-41-37-860-070-A (1) As necessary, use the applicable SAFETY BARRIERS, specified by the operator's instructions and your local regulations.
B. Aircraft Maintenance Configuration
(1) Fully extend the slats (Ref. AMM TASK 27-80-00-866-004).
(2) Make sure that the 98D27803000000 LOCKING TOOL-FLAP SLAT LEVER,INT. POSITION is installed on the flap/slat control lever.
(3) Put a WARNING NOTICE(S) in the cockpit to tell persons not to operate the slats.
(4) Put the ACCESS PLATFORM 4M (13 FT)-ADJUSTABLE in position below the applicable access panel 521GB(621GB).
Subtask 57-41-37-865-090-A (1) Fully extend the slats (Ref. AMM TASK 27-80-00-866-004).
(2) Make sure that the 98D27803000000 LOCKING TOOL-FLAP SLAT LEVER,INT. POSITION is installed on the flap/slat control lever.
(3) Put a WARNING NOTICE(S) in the cockpit to tell persons not to operate the slats.
(4) Put the ACCESS PLATFORM 4M (13 FT)-ADJUSTABLE in position below the applicable access panel 521GB(621GB).
C. Open, safety and tag this(these) circuit breaker(s):
Subtask 57-41-37-010-075-A ** ON A/C NOT FOR ALL 4. Procedure| PANEL | DESIGNATION | FIN | LOCATION |
|---|---|---|---|
| ** ON A/C NOT FOR ALL | |||
| 49VU | FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1 | 5CV | B06 |
| ** ON A/C NOT FOR ALL | |||
| 49VU | FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1 | 5CV | B01 |
| ** ON A/C ALL | |||
| 121VU | FLIGHT CONTROLS/SLT/CTL/SYS2 | 7CV | R21 |
Subtask 57-41-37-020-061-A
A. Removal of the Access Panel 521GB(621GB)
(1) Hold the access panel (1) and remove the bolts (2).
(2) Carefully remove the access panel (1).
(1) Hold the access panel (1) and remove the bolts (2).
(2) Carefully remove the access panel (1).
Access Panel 521GB(621GB) - Location and Detail