Reactivation of the Take-Off Light

TASK 33-46-00-440-002-A
Reactivation of the Take-Off Light

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

ZONE: 711
FIN: 7LR

1. Reason for the Job
CDL 33-09
Takeoff light lamp 7LR
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	1	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
711	NOSE GEAR

C. Referenced Information

REFERENCE	DESIGNATION
TASK 33-46-11-400-001-A	Installation of the Take Off Light
TASK 33-46-11-960-001-A	Replacement of the Lamp of the Take Off Light
TASK 33-46-11-960-802-A	Replacement of the Glass Assembly of the Take Off Light - (LED Light)
Take-Off Light - Location and Detail

3. Job Set-up
Subtask 33-46-00-941-053-A

A. Safety Precautions
(1) Put a WARNING NOTICE(S) in position on the EXT LT section of the overhead panel 25VU to tell persons not to operate the take-off light.

Subtask 33-46-00-865-057-A

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
122VU	LIGHTING/EXT LT/TAXI AND TAKE OFF/TO	3LR	W07

4. Procedure
Subtask 33-46-00-440-051-A ** ON A/C NOT FOR ALL

A. Reactivation of the Takeoff Light (7LR)
(1) If you removed the defective takeoff light during the deactivation procedure:
(a) Install the takeoff light (Ref. AMM TASK 33-46-11-400-001).
(b) Remove the placard on switch 4LR of panel 25VU.
(2) If you repaired the glass lens of the takeoff light:
(a) Remove the tape cover from the takeoff light.
(b) Replace the lens of the takeoff light (Ref. AMM TASK 33-46-11-960-001).

Subtask 33-46-00-440-051-B ** ON A/C NOT FOR ALL

5. Close-up
Subtask 33-46-00-865-058-A

A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
122VU	LIGHTING/EXT LT/TAXI AND TAKE OFF/TO	3LR	W07

Subtask 33-46-00-942-055-A

B. Put the aircraft back to its initial configuration.
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Remove the WARNING NOTICE(S).

[Rev.10 from 2021] 2026.04.01 00:55:46 UTC