Reactivation of the Taxi Light

TASK 33-46-00-440-001-A
Reactivation of the Taxi Light

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

ZONE: 711
FIN: 8LR

1. Reason for the Job
CDL 33-02
Taxi Light Lamp 8LR
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	1	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
711	NOSE GEAR

C. Referenced Information

REFERENCE	DESIGNATION
TASK 33-46-12-400-001-A	Installation of the Taxi Light
TASK 33-46-12-960-001-A	Replacement of the Lamp in the Taxi Light
TASK 33-46-12-960-802-A	Replacement of the Lens Assembly of the Taxi Light - (LED Light)
Taxi Light - Location and Detail

3. Job Set-up
Subtask 33-46-00-941-051-A

A. Safety Precautions
(1) Put a WARNING NOTICE(S) on the EXT LT section of the panel 25VU to tell persons not to operate the taxi light.

Subtask 33-46-00-865-053-A

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
122VU	LIGHTING/EXT LT/TAXI AND TAKE OFF/TAXI	1LR	W08

4. Procedure
Subtask 33-46-00-440-050-A ** ON A/C NOT FOR ALL

A. Reactivation of the Taxi Light (8LR)
(1) If you removed the defective taxi light during the deactivation procedure:
(a) Install the taxi light (Ref. AMM TASK 33-46-12-400-001).
(b) Removed the placard on switch 4LR of panel 25VU.
(2) If you repaired the glass lens of the taxi light:
(a) Remove the tape cover from the taxi light.
(b) Replace the lens of the taxi light (Ref. AMM TASK 33-46-12-960-001).

Subtask 33-46-00-440-050-B ** ON A/C NOT FOR ALL

5. Close-up
Subtask 33-46-00-865-054-A

A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
122VU	LIGHTING/EXT LT/TAXI AND TAKE OFF/TAXI	1LR	W08

Subtask 33-46-00-942-052-A

B. Put the aircraft back to its initial configuration.
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Remove the WARNING NOTICE(S).

[Rev.10 from 2021] 2026.04.01 00:55:43 UTC