Removal of the Floor Light

TASK 33-24-12-000-806-A
Removal of the Floor Light

FIN: 53LQ13 ** ON A/C NOT FOR ALL
FIN: 55LQ6 ** ON A/C NOT FOR ALL

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	CAP - BLANKING
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER

B. Referenced Information

REFERENCE	DESIGNATION
TASK 24-41-00-861-002-A	Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01	Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02	Energize the Aircraft Electrical Circuits from Engine 1(2)
Floor Light

3. Job Set-up
Subtask 33-24-12-860-063-A ** ON A/C NOT FOR ALL

A. Aircraft Maintenance Configuration
(1) Energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-861-002).

Subtask 33-24-12-865-070-A ** ON A/C NOT FOR ALL

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
49VU	LIGHTING/EMER LT/CABIN	79WL	H07
** ON A/C NOT FOR ALL
49VU	LIGHTING/EMER LT/CABIN	79WL	H05
** ON A/C NOT FOR ALL
2000VU	LAV FWD & MID-OCCUPIED	1WJ	F01
2000VU	LIGHT-LAV	1LQ	J01
2001VU	LAVATORY AFT-OCCUPIED	11WJ	B04

Subtask 33-24-12-010-055-A ** ON A/C NOT FOR ALL

C. Get Access
(1) Get Access to the Floor Light in the Spaceflex lavatory:
(a) FOR [53LQ13] (ACCENT LIGHT), [55LQ6] (ACCENT LIGHT)

Open the cabinet door.

4. Procedure
Subtask 33-24-12-020-056-A ** ON A/C NOT FOR ALL

A. Removal of the Floor Light in the Spaceflex Lavatory

Floor Light ** ON A/C NOT FOR ALL

(1) Remove the sealant from the opening (9).

CAUTION: MAKE MATCH MARKS ON ALL THE ELECTRICAL WIRES BEFORE YOU DISCONNECT THEM. INCORRECT CONNECTION OF WIRES WILL CAUSE DAMAGE TO EQUIPMENT.

CAUTION: MAKE SURE THAT THE ELECTRICAL CONNECTORS ARE CLEAN BEFORE YOU DISCONNECT OR CONNECT THEM. CONTAMINATION ON THE ELECTRICAL CONNECTORS CAN CAUSE DAMAGE TO EQUIPMENT.

(2) Disconnect the electrical connector (3).
(3) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(4) Cut and discard the TIE WRAPS (2) to release the cable (1).
(5) Support the shroud (6) and remove the screws (8) and the washers (7).
(6) Remove the shroud (6).
(7) Pull the floor light (4) to release it from the clamps (5).
(8) Remove the floor light (4).

[Rev.10 from 2021] 2026.04.01 06:20:11 UTC