Removal of the Accent Ceiling Light

TASK 33-24-12-000-803-A
Removal of the Accent Ceiling Light

ZONE: 200
FIN: 60LQ111 ** ON A/C NOT FOR ALL
FIN: 60LQ112 ** ON A/C NOT FOR ALL

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	CAP - BLANKING
No specific	1	PIN - NON METALLIC
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
200	UPPER HALF FUSELAGE

C. Referenced Information

REFERENCE	DESIGNATION
TASK 24-41-00-861-002-A	Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01	Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02	Energize the Aircraft Electrical Circuits from Engine 1(2)
Ceiling Light

3. Job Set-up
Subtask 33-24-12-860-068-A ** ON A/C NOT FOR ALL

A. Aircraft Maintenance Configuration
(1) Energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-861-002).

Subtask 33-24-12-865-075-A ** ON A/C NOT FOR ALL

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
49VU	LIGHTING/EMER LT/CABIN	79WL	H07
** ON A/C NOT FOR ALL
49VU	LIGHTING/EMER LT/CABIN	79WL	H05
** ON A/C NOT FOR ALL
2000VU	LAV FWD-OCCUPIED	1WJ	F01
** ON A/C NOT FOR ALL
2000VU	LIGHT-LAV	1LQ	J01
** ON A/C NOT FOR ALL
2000VU	LAV FWD & MID-OCCUPIED	1WJ	F01
** ON A/C NOT FOR ALL
2001VU	LAVATORY AFT-OCCUPIED	11WJ	B04

Subtask 33-24-12-010-056-A ** ON A/C NOT FOR ALL

C. Get Access
(1) Get Access to the Ceiling Light in the SMART lavatory:

Ceiling Light ** ON A/C NOT FOR ALL

(a) FOR 60LQ*

On the upper service panel (9), loosen the two studs (10) to open and lower the service panel (9).

4. Procedure
Subtask 33-24-12-020-057-A ** ON A/C NOT FOR ALL

A. Removal of the Ceiling Light

Ceiling Light ** ON A/C NOT FOR ALL

(1) Push the quick-release fastener (5) with PIN - NON METALLIC to disengage it.
(2) Move the cover (3) to the outboard direction until the hooks (4) release.
(3) Remove the cover (3).

CAUTION: MAKE SURE THAT THE ELECTRICAL CONNECTORS ARE CLEAN BEFORE YOU DISCONNECT OR CONNECT THEM. CONTAMINATION ON THE ELECTRICAL CONNECTORS CAN CAUSE DAMAGE TO EQUIPMENT.

(4) Disconnect the electrical connector (8).
(5) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(6) Cut and discard the TIE WRAPS (7) to release the cable (1).
(7) Pull the ceiling light (2) to release it from the clamps (6).
(8) Remove the ceiling light (2).

[Rev.10 from 2021] 2026.04.01 12:33:07 UTC