Procedure to Get Access to the SYSTEM REPORT/TEST Menu Page

TASK 31-32-00-860-001-A
Procedure to Get Access to the SYSTEM REPORT/TEST Menu Page

WARNING: MAKE SURE THAT ALL THE CIRCUITS IN MAINTENANCE ARE ISOLATED BEFORE YOU SUPPLY ELECTRICAL POWER TO THE AIRCRAFT. UNWANTED ELECTRICAL POWER CAN BE DANGEROUS.

NOTE: IGNORE ALL THE ECAM WARNINGS AS LONG AS THE COMPUTER IS IN THE MENU MODE.

ZONE: 210

1. Reason for the Job
To get access to the SYSTEM REPORT/TEST pages
This job gives access to the SYSTEM REPORT/TEST pages of the systems connected to the CFDS.
2. Job Set-up Information
A. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
210	CKPT,FWD COMPT BHD TO FLT COMPT BULKHEAD

B. Referenced Information

REFERENCE	DESIGNATION
TASK 24-41-00-861-002-A	Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01	Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02	Energize the Aircraft Electrical Circuits from Engine 1(2)
CFDS - SYSTEM REPORT/TEST - Menu Page

3. Job Set-up
Subtask 31-32-00-860-056-A

A. Energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-861-002).

Subtask 31-32-00-865-063-A

B. Make sure that this(these) circuit breaker(s) is(are) closed:

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
49VU	AUTO FLT/MCDU/1	11CA1	B01
** ON A/C NOT FOR ALL
49VU	AUTO FLT/MCDU/1	11CA1	H07
** ON A/C NOT FOR ALL
121VU	CFDS/CFDIU/SPLY	2TW	J18
121VU	CFDS/CFDIU/BACK/UP	8TW	J17
** ON A/C ALL
121VU	AUTO FLT/MCDU/2	11CA2	N20
** ON A/C NOT FOR ALL
121VU	CFDS/CFDIU/SPLY	2TW	J41
121VU	CFDS/CFDIU/BACK/UP	8TW	J40

4. Procedure
Subtask 31-32-00-860-057-A

A. Access to the SYSTEM REPORT/TEST Menu Pages

CFDS - SYSTEM REPORT/TEST - Menu Page

NOTE: The procedure below is applicable to the MCDU 1 or 2.
The actions and the results of this procedure occur on the MCDU used.

NOTE: After a power-up of the CFDS:

The CFDS prompt is shown in the MCDU MENU page after approximately 60 seconds.
The full CFDS functionality is available after approximately 3 minutes, to make computation of the A/C configuration possible.

ACTION	RESULT
On the MCDU: Adjust the brightness of the MCDU screen:
push the MCDU MENU mode key.	On the MCDU: the MCDU MENU page comes into view.
push the line key adjacent to the CFDS indication.	the CFDS MENU page comes into view.
push the line key adjacent to the SYSTEM REPORT/TEST indication.	the SYSTEM REPORT/TEST page comes into view
if the page shown is not applicable, push the NEXT PAGE fonction key.

[Rev.10 from 2021] 2026.04.01 04:29:12 UTC