Removal of the Hoisting Sling

TASK 27-80-00-000-001-A
Removal of the Hoisting Sling

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

1. Reason for the Job
Self Explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	SAFETY BARRIER(S)
No specific	AR	WARNING NOTICE(S)
98D27803000000	1	LOCKING TOOL-FLAP SLAT LEVER,INT. POSITION

B. Referenced Information

REFERENCE	DESIGNATION
TASK 11-00-00-400-022-A	Installation of the Hoisting-Point Cover Patches
TASK 27-80-00-866-004-A	Extending the Slats on the Ground
Hoisting Sling

3. Job Set-up
Subtask 27-80-00-941-057-A

A. Safety Precautions
(1) Make sure that the WARNING NOTICE(S) are in position to tell persons not to operate the slat controls.
(2) Make sure that the SAFETY BARRIER(S) are in position.

Subtask 27-80-00-860-050-A

B. Aircraft Maintenance Configuration
(1) Make sure that the slats are fully extended (Ref. AMM TASK 27-80-00-866-004).
(2) Make sure that the 98D27803000000 LOCKING TOOL-FLAP SLAT LEVER,INT. POSITION is installed on the slat/flap control lever on panel 114VU.

4. Procedure
Subtask 27-80-00-080-050-B

A. Removal of the Hoisting Sling
(1) Remove the trailing edge block (7) from the trailing edge of the slat.
(2) Remove the pip-pins (4) and disconnect the 98D27804009001 SLATS - SLING from the slat.
(3) Remove the lifting lugs (5) from the slat and connect them to the hoisting sling with the pip-pins (4).
(4) Remove the hoisting sling from the hoist.
(5) Install the blanking caps in the slat. Make sure that the top of the blanking caps are not above the surface of the slat.
(6) Do the Installation of the Hoisting Sling Cover Patches (Ref. AMM TASK 11-00-00-400-022).

5. Close-up
Subtask 27-80-00-942-056-A

A. Removal of Equipment
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Remove the safety barriers.
(3) Remove the WARNING NOTICE(S).
(4) Remove the ground support and maintenance equipment, the special and standard tools and all other items.

[Rev.10 from 2021] 2026.03.31 23:56:14 UTC