Removal of the Smoke Detector of Lavatory DS/ES/HS
TASK 26-17-15-000-808-A
Removal of the Smoke Detector of Lavatory DS/ES/HS
1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Work Zones and Access Panels
C. Referenced Information
3. Job Set-up
Subtask 26-17-15-860-065-A ** ON A/C NOT FOR ALL
Subtask 26-17-15-020-065-A ** ON A/C NOT FOR ALL
[Rev.10 from 2021]
2026.03.31 23:44:17 UTC
Removal of the Smoke Detector of Lavatory DS/ES/HS
1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | AR | CAP - BLANKING |
| No specific | AR | SAFETY CLIP - CIRCUIT BREAKER |
| ZONE/ACCESS | ZONE DESCRIPTION |
|---|---|
| 200 | UPPER HALF FUSELAGE |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 24-41-00-861-002-A | Energize the Aircraft Electrical Circuits from the External Power |
| TASK 24-41-00-861-002-A-01 | Energize the Aircraft Electrical Circuits from the APU |
| TASK 24-41-00-861-002-A-02 | Energize the Aircraft Electrical Circuits from Engine 1(2) |
| TASK 26-17-00-00 | LAVATORY SMOKE DETECTION - DESCRIPTION AND OPERATION |
Subtask 26-17-15-860-065-A ** ON A/C NOT FOR ALL
A. Aircraft Maintenance Configuration
(1) Energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-861-002).
Subtask 26-17-15-865-100-A ** ON A/C NOT FOR ALL (1) Energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-861-002).
B. Open, safety and tag this(these) circuit breaker(s):
Subtask 26-17-15-010-079-A ** ON A/C NOT FOR ALL | PANEL | DESIGNATION | FIN | LOCATION |
|---|---|---|---|
| ** ON A/C NOT FOR ALL | |||
| 49VU | COM/CIDS/DEU B/ESS | 153RH | G03 |
| ** ON A/C NOT FOR ALL | |||
| 121VU | COM NAV/CIDS/DEU B/NORM | 162RH | M08 |
| ** ON A/C NOT FOR ALL | |||
| 121VU | COM/CIDS/DEU B/BAT | 143RH | N12 |
| ** ON A/C NOT FOR ALL | |||
| 121VU | COM / CIDS / DEU B / NORM FWD | 193RH | M09 |
| 2001VU | CIDS-DEU B-NORM-AFT | 194RH | C08 |
C. Get Access
(1) For the location of this component refer to (Ref. AMM D/O 26-17-00-00).
(2) Get access to the related lavatory.
(3) Get access to the smoke detector (3):
(a) Remove the screws (9) and the air extraction grille (8).
(b) Remove the air filter (13) and the grille (12) from the air extraction hood (6).
(c) Remove the screws (11) and the washers (10).
(d) Carefully lower the panel (5).
4. Procedure(1) For the location of this component refer to (Ref. AMM D/O 26-17-00-00).
(2) Get access to the related lavatory.
(3) Get access to the smoke detector (3):
(a) Remove the screws (9) and the air extraction grille (8).
(b) Remove the air filter (13) and the grille (12) from the air extraction hood (6).
(c) Remove the screws (11) and the washers (10).
(d) Carefully lower the panel (5).
Subtask 26-17-15-020-065-A ** ON A/C NOT FOR ALL
A. Removal of the Smoke Detector
(2) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(3) Remove the nuts (7) and the screws (1).
(4) Carefully remove the smoke detector (3) and the seal (4) from the air-extraction hood (6).
CAUTION:
MAKE SURE THAT THE ELECTRICAL CONNECTORS ARE CLEAN BEFORE YOU DISCONNECT OR CONNECT THEM. CONTAMINATION ON THE ELECTRICAL CONNECTORS CAN CAUSE DAMAGE TO EQUIPMENT.
(1) Disconnect the electrical connector (2) from the smoke detector (3). (2) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(3) Remove the nuts (7) and the screws (1).
(4) Carefully remove the smoke detector (3) and the seal (4) from the air-extraction hood (6).
Smoke Detector of Lavatory DS/ES/HS