Removal of the Mirror of the Space Flex Lavatory

TASK 25-45-13-000-802-A
Removal of the Mirror of the Space Flex Lavatory

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	CAP - BLANKING

B. Referenced Information

REFERENCE	DESIGNATION
TASK 24-41-00-862-002-A	De-energize the Aircraft Electrical Circuits Supplied from the External Power
TASK 24-41-00-862-002-A-01	De-energize the Aircraft Electrical Circuits Supplied from the APU
TASK 24-41-00-862-002-A-02	De-energize the Aircraft Electrical Circuits Supplied from the Engine 1(2)
TASK 24-42-00-861-001-A	Energize the Ground Service Network from the External Power
TASK 25-45-14-000-802-A	Removal of the Soap Dispenser of the Space Flex Lavatory
TASK 25-45-23-000-802-A	Removal of the Hand Grip of the Space Flex Lavatory
Mirror of the Space Flex Lavatory

3. Job Set-up
Subtask 25-45-13-861-051-A ** ON A/C NOT FOR ALL

A. Aircraft Maintenance Configuration
(1) Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).
(2) Make sure that the aircraft electrical circuits are de-energized
(Ref. AMM TASK 24-41-00-862-002).

Subtask 25-45-13-010-052-A ** ON A/C NOT FOR ALL

B. Get Access
(1) If necessary, remove the soap dispenser (Ref. AMM TASK 25-45-14-000-802).
(2) If necessary, remove the hand grip (Ref. AMM TASK 25-45-23-000-802).

4. Procedure
Subtask 25-45-13-020-052-A ** ON A/C NOT FOR ALL

A. Removal of the Mirror of the Space Flex Lavatory

Mirror of the Space Flex Lavatory ** ON A/C NOT FOR ALL

(1) Remove the mirror (1) as follows:
(a) Remove the screws (6) and the Passenger Service Unit (PSU) (5).
(b) Remove the screws (4) and the washers (3) from the brackets (2).

WARNING: WHEN YOU DISCONNECT THE ELECTRICAL CONNECTOR, ALWAYS PUT ON PROTECTIVE GLOVES AND GOGGLES TO PREVENT INJURY.

(c) Hold the mirror (1), then disconnect the electrical connectors (8) and (9).
(d) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(e) If necessary, safety the electrical connectors (8) and (9) to the lavatory.
(f) Disengage the mirror (1) from the clips (7) and remove the mirror (1).
(2) Remove the mirror (10) as follows:
(a) Pull the mirror (10) to release the pins (11) from the supports (12).
(b) Remove the mirror (10).

[Rev.10 from 2021] 2026.04.01 06:22:19 UTC