Servicing of the Rain Repellent Fluid Can

TASK 30-45-00-600-001-A
Servicing of the Rain Repellent Fluid Can

WARNING: DO NOT GET THE FLUID ON YOUR SKIN OR IN YOUR EYES. IF YOU DO:

FLUSH IT AWAY WITH CLEAN WATER
GET MEDICAL AID.

WARNING: MAKE SURE THAT YOU DEPRESSURIZE THE RAIN REPELLENT SYSTEM BEFORE YOU REMOVE THE RAIN REPELLENT FLUID-CAN. RAIN REPELLENT FLUID CAN COME OUT SUDDENLY IF YOU REMOVE THE FLUID CAN WITH THE SYSTEM PRESSURIZED.

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

CAUTION: MAKE SURE THAT THE FLUID DOES NOT STAY ON THE AIRCRAFT STRUCTURE. IF THE FLUID GETS ON THE AIRCRAFT STRUCTURE, WASH IT OFF IMMEDIATELY WITH SOAP AND WATER.

NOTE: If there is leakage of FORALKYL 2211, you can smell a pine odor.

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	CONTAINER 5 L (1.32 USGAL)
No specific	1	HOSE - DRAIN
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	AR	WARNING NOTICE(S)

B. Consumable Materials

REFERENCE	DESIGNATION
(Material No.08BBD1)	Non Aqueous Cleaner-- Isopropyl Alcohol -

C. Expendable Parts

FIG.ITEM	DESIGNATION	IPC-CSN
3	SEAL	AIPC 30-45-01-06-027
3	SEAL	AIPC 30-45-81-06-060

D. Referenced Information

REFERENCE	DESIGNATION
TASK 24-42-00-861-001-A	Energize the Ground Service Network from the External Power
TASK 24-42-00-862-001-A	De-energize the Ground Service Network Supplied from the External Power
Rain Repellent Fluid Can

3. Job Set-up
Subtask 30-45-00-100-051-A

A. Cleaning Instructions.
Make sure that the fluid does not stay on the aircraft furnishing.
If the fluid gets on the aircraft furnishings, clean with Non Aqueous Cleaner-- Isopropyl Alcohol - (Material No.08BBD1) .

Subtask 30-45-00-861-052-A

B. Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).

Subtask 30-45-00-010-052-A

C. Open the access door of the rain-repellent fluid can.

Subtask 30-45-00-865-054-A

D. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
49VU	ANTI ICE/RAIN/RPLNT/CAPT	1DB1	D01
122VU	ANTI ICE/RAIN/RPLNT/F/O	1DB2	W11

Subtask 30-45-00-941-055-A

E. On the overhead control and indicating panel 21VU and overhead control and indicating panel 22VU, put a WARNING NOTICE(S) to tell persons not to operate the rain-repellent pushbutton switches.

4. Procedure
Subtask 30-45-00-941-053-A

A. Preparation
(1) Connect a HOSE - DRAIN to the drain valve (5) of the rain-repellent fluid-gage assembly (4).
(2) Put the hose outlet in a CONTAINER 5 L (1.32 USGAL).

Subtask 30-45-00-870-050-A

B. Depressurisation of the System

CAUTION: MAKE SURE THAT THE HOSE OUTLET IS IN THE CONTAINER.

(1) Push the pushbutton (6) of the rain-repellent fluid-gage assembly (4) to depressurize the system.

Subtask 30-45-00-020-050-A

C. Removal of the Rain-Repellent Fluid Can
(1) Remove the clamp (2).
(2) Remove the can (1).
(3) Remove the seal (3) and discard it.
(4) Put blanking plugs on the open ports.

Subtask 30-45-00-420-050-A

D. Installation of the New Rain-Repellent Fluid Can
(1) Clean the component interfaces and the adjacent area.
(2) Do an inspection of the component interfaces and the adjacent area.
(3) Remove the blanking plugs from the new can (1) and the rain-repellent fluid-gage assembly (4) receptacle.
(4) Install a new AIPC 30-45-01-06-027 SEAL (3) or AIPC 30-45-81-06-060 SEAL (3) into the inlet port of the rain-repellent fluid-gage assembly (4).
(5) Install the can (1) on its receptacle.

NOTE: The instructions for assembly are given on the plate installed adjacent to the can.

(6) Put the clamp (2) in the correct position on the can (1).
(7) Torquing of the clamp (2)

CAUTION: DO NOT TORQUE THE RETAINING COLLAR SCREW OF THE CLAMP TO MORE THAN ITS MAXIMUM TORQUE VALUE OF 0.2 M.DAN (17.70 LBF.IN). IF YOU DO, YOU CAN CAUSE DAMAGE TO THE CAN.

(a) Do not torque the retaining collar screw of the clamp (2) more than 0.2 m.daN (17.70 lbf.in).

Subtask 30-45-00-210-052-A

E. Inspection/Check

CAUTION: MAKE SURE THAT THE HOSE OUTLET IS IN THE CONTAINER.

(1) Push the pushbutton (6) of the rain-repellent fluid-gage assembly (4).
(2) Make sure that the fluid level is correct and increases to the correct pressure.
(3) Make sure that there are no leaks.

Subtask 30-45-00-942-053-A

F. Disconnect the hose from the drain valve and remove the container from the aircraft.

5. Close-up
Subtask 30-45-00-865-055-A

A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
49VU	ANTI ICE/RAIN/RPLNT/CAPT	1DB1	D01
122VU	ANTI ICE/RAIN/RPLNT/F/O	1DB2	W11

Subtask 30-45-00-410-052-A

B. Close Access
(1) Close the access door of the rain-repellent fluid can.
(2) Remove the WARNING NOTICE(S).

Subtask 30-45-00-862-052-A

C. De-energize the ground service network
(Ref. AMM TASK 24-42-00-862-001).

[Rev.10 from 2021] 2026.04.01 04:35:20 UTC