Removal of the Activation Identification Module (AIM)

TASK 25-65-35-000-006-A
Removal of the Activation Identification Module (AIM)

ZONE: 200
ZONE: 260

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
200	UPPER HALF FUSELAGE
260	AFT CABIN UTILITY AREA
261BC

B. Referenced Information

REFERENCE	DESIGNATION
TASK 24-42-00-861-001-A	Energize the Ground Service Network from the External Power
TASK 25-23-42-000-002-A	Removal of the Ceiling Panels - Aft Utility Area
Activation / Identification Module (AIM)

3. Job Set-up
Subtask 25-65-35-861-055-A ** ON A/C NOT FOR ALL

A. Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).

Subtask 25-65-35-010-057-A ** ON A/C NOT FOR ALL

B. Get access to the AIM
(1) Remove the ceiling panel 261BC (Ref. AMM TASK 25-23-42-000-002).

4. Procedure
Subtask 25-65-35-020-055-A ** ON A/C NOT FOR ALL

A. Removal of the AIM

Activation / Identification Module (AIM) ** ON A/C NOT FOR ALL

CAUTION: PULL THE TOGGLE SWITCH BEFORE YOU SET IT TO THE "ON", "OFF" OR "ARMED" POSITION. IF YOU DO NOT OBEY THIS INSTRUCTION, YOU CAN CAUSE DAMAGE TO THE EMERGENCY LOCATOR TRANSMITTER.

(1) Set the toggle switch (9) to the OFF position.
(2) Remove the screw (8) and the wire lanyard (7) from the aircraft structure (2).
(3) Remove the screws (5) and carefully pull the AIM (4) out of the ELT (1).
(4) Remove and keep the O-ring seal (3).

[Rev.10 from 2021] 2026.03.31 23:41:27 UTC