Removal of the Programming Dongle

TASK 25-65-35-000-003-A
Removal of the Programming Dongle

ZONE: 200

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	CAP - BLANKING

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
200	UPPER HALF FUSELAGE
261BC

C. Referenced Information

REFERENCE	DESIGNATION
TASK 24-42-00-861-001-A	Energize the Ground Service Network from the External Power
TASK 25-23-42-000-002-A	Removal of the Ceiling Panels - Aft Utility Area
DONGLE (141 MX) ** ON A/C NOT FOR ALL
DONGLE (141 MX) ** ON A/C NOT FOR ALL

3. Job Set-up
Subtask 25-65-35-861-052-B ** ON A/C NOT FOR ALL

A. Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).

Subtask 25-65-35-010-053-B ** ON A/C NOT FOR ALL

B. Get access to the Programming Dongle
(1) Remove the ceiling panel 261BC (Ref. AMM TASK 25-23-42-000-002).

4. Procedure
Subtask 25-65-35-020-052-B ** ON A/C NOT FOR ALL

A. Removal of the Programming Dongle 141MX

DONGLE (141 MX) ** ON A/C NOT FOR ALL

(1) Set the ON/OFF/ARM switch (6) to the OFF position.
(2) Disconnect the electrical connector (3) or programming-dongle (2) from the connector (7) of the ELT (4).
(3) Disconnect the electrical connector (1) from the bracket (5).
(4) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.

[Rev.10 from 2021] 2026.03.31 23:41:23 UTC