Installation of the Hand Grip

TASK 25-45-23-400-001-A
Installation of the Hand Grip

ZONE: 200

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
200	UPPER HALF FUSELAGE

B. Referenced Information

REFERENCE	DESIGNATION
TASK 24-42-00-861-001-A	Energize the Ground Service Network from the External Power
TASK 24-42-00-862-001-A	De-energize the Ground Service Network Supplied from the External Power
Hand Grip

3. Job Set-up
Subtask 25-45-23-860-050-A

A. Aircraft Maintenance Configuration
(1) Make sure that the ground service network is energized
(Ref. AMM TASK 24-42-00-861-001).

4. Procedure
Subtask 25-45-23-210-050-A

A. Preparation for Installation
(1) Clean the component interfaces and the adjacent area.
(2) Make sure that the parts retained from the removed component are clean and in the correct condition.
(3) Do an inspection of the component interfaces and the adjacent area.

Subtask 25-45-23-420-050-A

B. Installation of the Hand Grip

Hand Grip

(1) Put the hand grip (1) on the special screws (3).
(2) Install the pins (2). If the pin holes are not aligned, do the following;
(a) Remove the grip handle (1).
(b) Adjust the special screws (3).
(c) Do para B. (2) again.

5. Close-up
Subtask 25-45-23-862-050-A

A. De-energize the ground service network
(Ref. AMM TASK 24-42-00-862-001).

[Rev.10 from 2021] 2026.03.31 23:36:28 UTC