Installation of the Oven Control Module

TASK 25-35-19-400-004-A
Installation of the Oven Control Module

ZONE: 200

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
200	UPPER HALF FUSELAGE

B. Referenced Information

REFERENCE	DESIGNATION
TASK 24-42-00-861-001-A	Energize the Ground Service Network from the External Power
TASK 25-35-00-710-015-A	Operational Test of the Oven
Oven Control Module

3. Job Set-up
Subtask 25-35-19-861-060-A ** ON A/C NOT FOR ALL

A. Aircraft Maintenance Configuration
(1) Make sure that the ground service network is energized
(Ref. AMM TASK 24-42-00-861-001).

Subtask 25-35-19-860-071-A ** ON A/C NOT FOR ALL

B. At the related galley on the galley control panel:
(1) Make sure that the related circuit breaker(s) of the oven is(are) open, safetied and tagged.

4. Procedure
Subtask 25-35-19-420-053-B ** ON A/C NOT FOR ALL

A. Installation of the Oven Control Module (OCM)

Oven Control Module ** ON A/C NOT FOR ALL

(1) Remove the CAP-BLANKING from each electrical connector and receptacle.
(2) Make sure that all the electrical connections are clean and in the correct condition.
(3) Put the OCM (1) on the mounting rails (2).
(4) Carefully push the OCM (1) into the galley to connect the electrical connectors.

Subtask 25-35-19-710-054-A ** ON A/C NOT FOR ALL

B. Test
(1) Do the operational test of the oven (Ref. AMM TASK 25-35-00-710-015).

5. Close-up
Subtask 25-35-19-410-055-A ** ON A/C NOT FOR ALL

A. Close Access
(1) Make sure that the work area is clean and clear of tools and other items.

[Rev.10 from 2021] 2026.03.31 23:34:31 UTC