71-00 (CFMI) - POWER PLANT

71-00-00 (CFMI) - POWER PLANT

PB.001 POWER PLANT - DESCRIPTION AND OPERATION
PB.201 POWER PLANT - MAINTENANCE PRACTICES
- 71-00-00-820-001-A [CFMI] [10]
  Oil Circuit Air Flow Check
PB.401 POWER PLANT - DEACTIVATION/REACTIVATION
- 71-00-00-000-040-A [CFMI] [10]
  Removal of the Power Plant
- 71-00-00-000-040-A-01 [CFMI] [10]
  Removal of the Power Plant with the Engine Positioner TWW 75E
- 71-00-00-000-040-A-03 [CFMI] [10]
  Removal of the Power Plant with Jacxson Tool
- 71-00-00-400-040-A [CFMI] [10]
  Installation of the Power Plant
- 71-00-00-400-040-A-01 [CFMI] [10]
  Installation of the Power Plant with the Engine Positioner TWW 75E
- 71-00-00-400-040-A-03 [CFMI] [10]
  Installation of the Power Plant with Jacxson Tool
PB.501 POWER PLANT - ADJUSTMENT/TEST
- 71-00-00-869-005-A [CFMI] [10]
  Wind Limitations During Engine Ground Operations
- 71-00-00-869-006-A [CFMI] [10]
  Safety Precautions During Engine Ground Operations
- 71-00-00-710-001-A [CFMI] [10]
  Dry Motoring Check
- 71-00-00-710-002-A [CFMI] [10]
  Wet Motoring Check
- 71-00-00-710-003-A [CFMI] [10]
  Engine Automatic Start
- 71-00-00-710-004-A [CFMI] [10]
  Engine Manual Start
- 71-00-00-710-005-A [CFMI] [10]
  Start Abort
- 71-00-00-710-006-A [CFMI] [10]
  Minimum Idle Check
- 71-00-00-710-008-A [CFMI] [10]
  Power Assurance Check
- 71-00-00-710-009-A [CFMI] [10]
  Vibration Check
- 71-00-00-710-010-A [CFMI] [10]
  Accel Check
- 71-00-00-710-028-A [CFMI] [10]
  Engine Shutdown
- 71-00-00-750-001-A [CFMI] [10]
  Fan Trim Balance - 1 Sensor 3 Speed
- 71-00-00-750-001-A-01 [CFMI] [10]
  Fan Trim Balance - 1 Sensor 1 Speed
- 71-00-00-869-001-A [CFMI] [10]
  Abnormal Operation and Emergency Procedures
- 71-00-00-790-001-A [CFMI] [10]
  Leak Test of the Accessory-Gearbox (AGB) Carbon Seal
- 71-00-00-790-004-A [CFMI] [10]
  Leak Check after the Replacement of a Sealol Seal or a Magnetic Seal on the AGB Drive Pads of the IDG, Hydraulic Pump, Starter and Fuel Pump
- 71-00-00-790-007-A [CFMI] [10]
  Leak Test of the Accessory Gearbox pad (AGB) Starter cavity (between equipement and AGB)
- 71-00-00-790-002-A [CFMI] [10]
  Fuel or Hydraulic or Oil Leakage Limits
- 71-00-00-790-003-A [CFMI] [10]
  Drain Mast Leakage Identification Procedure
- 71-00-00-860-002-A [CFMI] [10]
  Engine Start in Cold Weather Conditions (OAT Less Than -40 Degrees)