DOC AIRBUS | TSM A320FEngine Flameout Detected
TASK 71-00-00-810-867-A
Engine Flameout Detected
1. Possible Causes
2. Job Set-up Information
A. Referenced Information
3. Fault Confirmation
Subtask 71-00-00-710-131-A ** ON A/C NOT FOR ALL
Subtask 71-00-00-860-085-A ** ON A/C NOT FOR ALL
[Rev.8 from Aug 2018]
2026.04.04 04:35:05 UTC
Engine Flameout Detected
1. Possible Causes
2. Job Set-up Information
A. Referenced Information
| REFERENCE | DESIGNATION |
|---|---|
| TSM TASK 71-00-00-810-834-A | General Troubleshooting Guidelines for Additional Troubleshooting Information |
| TSM TASK 71-00-00-810-835-A | Component and Harness Intermittent Troubleshooting Procedure for Guidance Troubleshooting Intermittent Faults |
| TSM TASK 71-00-00-810-853-A | Troubleshoot the Engine after a Flame Out - No/Low Fuel Flow event |
| TSM TASK 71-00-00-810-871-A | Troubleshoot the Engine after a Flame Out - Fuel Flow Normal event |
Subtask 71-00-00-710-131-A ** ON A/C NOT FOR ALL
A. Not Applicable
4. Fault IsolationNOTE: The Electronic Engine Control (EEC) has detected an engine flameout event.
- Refer to the general troubleshooting guidelines for additional troubleshooting information (Ref. TSM TASK 71-00-00-810-834).
- Refer to the component and harness intermittent troubleshooting procedure for guidance troubleshooting intermittent faults (Ref. TSM TASK 71-00-00-810-835).
WARNING:
BE CAREFUL WHEN YOU DO WORK ON THE ENGINE AFTER SHUTDOWN. THE ENGINE CAN STAY HOT FOR A LONG TIME. IF YOU DO NOT OBEY THIS WARNING, INJURY CAN OCCUR.
WARNING:
REFER TO THE MSDS FOR ALL MATERIAL USED AND THE MANUFACTURER'S SAFETY INSTRUCTIONS FOR ALL EQUIPMENT USED. IF YOU DO NOT OBEY THIS WARNING, INJURY CAN OCCUR.
Subtask 71-00-00-810-138-A ** ON A/C NOT FOR ALL A. Do the step that follows:
(1) If the maintenance messages related to the engine flameout have been set, refer to the observed fault troubleshooting procedures troubleshoot the engine after an engine flameout event , refer to (Ref. TSM TASK 71-00-00-810-853) for no or low fuel flow, or refer to (Ref. TSM TASK 71-00-00-810-871) for normal fuel flow.
5. Close-up(1) If the maintenance messages related to the engine flameout have been set, refer to the observed fault troubleshooting procedures troubleshoot the engine after an engine flameout event , refer to (Ref. TSM TASK 71-00-00-810-853) for no or low fuel flow, or refer to (Ref. TSM TASK 71-00-00-810-871) for normal fuel flow.
Subtask 71-00-00-860-085-A ** ON A/C NOT FOR ALL
A. Put the aircraft back to its initial configuration.
(1) Make sure that the work area is clean and clear of tools and other items.
(1) Make sure that the work area is clean and clear of tools and other items.