Loss of the ACS2 Signal of the ELAC2 MON Side

TASK 27-90-00-810-810-A
Loss of the ACS2 Signal of the ELAC2 MON Side

1. Possible Causes

ELAC-2 [2CE2]
wiring of the ACS2 signal from the ELAC2 MON side to the first terminal block

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
TSM TASK 27-90-00-810-801-A	Failure of an Alternating Current Supply (ACS)
ASM 279303
AMM 27-93-34-000-001	Removal of the ELAC
AMM 27-93-34-400-001	Installation of the ELAC
AMM 27-96-00-740-001	BITE Test of the EFCS (Ground Scanning)

3. Fault Confirmation
Subtask 27-90-00-740-066-A

A. Test
Do the BITE Test of the EFCS (Ground Scanning) AMM 27-96-00-740-001.

4. Fault Isolation
Subtask 27-90-00-810-059-A

A. If the test gives the maintenance messages:
L G AIL MODE XDCR 33CE1 OR INPUT OF ELAC2
and
R G AIL MODE XDCR 33CE4 OR INPUT OF ELAC2

remove the ELAC2 AMM 27-93-34-000-001.

(1) At the ELAC2 receptacle, do a check of the resistance and of the insulation between the pin AD/2C and the pin AD/2D (15 to 250 ohms) ASM 279303.
(a) If the resistance values are in the specified limits:

replace the ELAC-2 [2CE2] AMM 27-93-34-000-001 and AMM 27-93-34-400-001.

(b) If the resistance is less than 15 ohms:
1 Do the trouble shooting procedure (Ref. TSM TASK 27-90-00-810-801).
2 Replace the ELAC-2 [2CE2] AMM 27-93-34-000-001 and AMM 27-93-34-400-001.
(c) If the resistance is more than 250 ohms:
1 Do a check and repair the wiring of the ACS2 signal from the ELAC2 MON side to the first terminal block ASM 279303.
2 Install the ELAC2 AMM 27-93-34-400-001.

Subtask 27-90-00-740-067-A

B. Do the test given in Para. 3.

[Rev.8 from Aug 2018] 2026.04.04 04:27:52 UTC