Removal of the Low Pressure Turbine Active Clearance Control (LPTACC) Fuel Tube Manifold [CFMB]
TASK 73-11-30-000-001-A
Removal of the Low Pressure Turbine Active Clearance Control (LPTACC) Fuel Tube Manifold
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Work Zones and Access Panels
C. Referenced Information
3. Job Set-up
Subtask 73-11-30-941-053-A ** ON A/C NOT FOR ALL
Subtask 73-11-30-020-050-A ** ON A/C NOT FOR ALL
[Rev.10 from 2021]
2026.04.01 13:05:19 UTC
Removal of the Low Pressure Turbine Active Clearance Control (LPTACC) Fuel Tube Manifold
WARNING:
BE CAREFUL WHEN YOU DO WORK ON THE ENGINE AFTER SHUTDOWN. THE ENGINE CAN STAY HOT FOR A LONG TIME. IF YOU DO NOT OBEY THIS INSTRUCTION, INJURY CAN OCCUR.
1. Reason for the JobSelf explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | AR | ACCESS PLATFORM 1M(3 FT) |
| No specific | AR | CONTAINER 20L (5 USGAL) |
| No specific | AR | WARNING NOTICE(S) |
| ZONE/ACCESS | ZONE DESCRIPTION |
|---|---|
| 400 | POWER PLANT, NACELLES AND PYLONS |
| FOR [1000EM1] (ENGINE-1) | |
| 437AL, 438AR, 451AL, 452AR | |
| FOR [1000EM2] (ENGINE-2) | |
| 447AL, 448AR, 461AL, 462AR | |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 71-13-00-010-040-B | Opening of the Fan Cowl Doors |
| TASK 78-30-00-481-041-B | Make the Thrust Reverser Unserviceable for Maintenance |
| TASK 78-36-00-010-040-B | Opening of the Thrust Reverser Doors |
Subtask 73-11-30-941-053-A ** ON A/C NOT FOR ALL
A. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(a) Put a WARNING NOTICE(S) to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a WARNING NOTICE(S) to tell persons not to energize the FADEC 1(2).
Subtask 73-11-30-010-056-A ** ON A/C NOT FOR ALL (1) On the center pedestal, on the ENG panel 115VU:
(a) Put a WARNING NOTICE(S) to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a WARNING NOTICE(S) to tell persons not to energize the FADEC 1(2).
B. Get Access
(1) Open the fan cowls doors (Ref. AMM TASK 71-13-00-010-040):
(a) FOR [1000EM1] (ENGINE-1)
437AL 438AR
(b) FOR [1000EM2] (ENGINE-2)
447AL 448AR
(2) Put the ACCESS PLATFORM 1M(3 FT) in position.
Subtask 73-11-30-040-053-A ** ON A/C NOT FOR ALL Subtask 73-11-30-010-057-A ** ON A/C NOT FOR ALL (1) Open the fan cowls doors (Ref. AMM TASK 71-13-00-010-040):
(a) FOR [1000EM1] (ENGINE-1)
437AL 438AR
(b) FOR [1000EM2] (ENGINE-2)
447AL 448AR
(2) Put the ACCESS PLATFORM 1M(3 FT) in position.
D. Open the thrust reverser doors (Ref. AMM TASK 78-36-00-010-040):
(1) FOR [1000EM1] (ENGINE-1)
451AL 452AR
(2) FOR [1000EM2] (ENGINE-2)
461AL 462AR
4. Procedure(1) FOR [1000EM1] (ENGINE-1)
451AL 452AR
(2) FOR [1000EM2] (ENGINE-2)
461AL 462AR
Subtask 73-11-30-020-050-A ** ON A/C NOT FOR ALL
A. Removal of the LPTACC fuel manifold
(2) Remove the four bolts (30) which attach the LPTACC fuel manifold (20) to the LPTACC valve (10). Remove and retain the gasket (40).
(3) Remove the four bolts (60) and the four nuts (50) that attach the LPTACC fuel manifold (20) to the fuel manifold (80). Remove and retain the gasket (70).
WARNING:
BE CAREFUL NOT TO GET AIRCRAFT FUEL IN YOUR MOUTH OR IN YOUR EYES.
IF YOU GET FUEL ON YOUR SKIN OR ON YOUR CLOTHES, FLUSH IT IMMEDIATELY WITH WATER.
IF NECESSARY, GET MEDICAL HELP.
AIRCRAFT FUEL IS POISONOUS.
WARNING:
USE A CORRECT CONTAINER AND KEEP THE CONTAINER AWAY FROM FLAMES SO THAT FIRES DO NOT OCCUR.
(1) Place CONTAINER 20L (5 USGAL) below the fuel manifold (80). (2) Remove the four bolts (30) which attach the LPTACC fuel manifold (20) to the LPTACC valve (10). Remove and retain the gasket (40).
(3) Remove the four bolts (60) and the four nuts (50) that attach the LPTACC fuel manifold (20) to the fuel manifold (80). Remove and retain the gasket (70).
Removal/Installation of the LPTACC Fuel Tube Manifold