Removal of the Fan Disk Shields [CFML]

TASK 72-21-44-000-801-A
Removal of the Fan Disk Shields

WARNING: BE CAREFUL WHEN YOU DO WORK ON THE ENGINE PARTS AFTER THE ENGINE SHUTDOWN. USE APPLICABLE THERMAL GLOVES. THE ENGINE PARTS CAN STAY HOT FOR ONE HOUR AFTER SHUTDOWN AND CAN BURN YOU.

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 1M(3 FT)
No specific	1	MAT - PROTECTIVE
No specific	AR	WARNING NOTICE(S)

B. Referenced Information

REFERENCE	DESIGNATION
TASK 72-21-20-000-801-A	Removal of the Fan Blades
Fan Disk Shields

3. Job Set-up
Subtask 72-21-44-941-050-A

A. Safety Precautions
(1) On the center pedestal, on ENG panel 115VU:
(a) Make sure that the ENG/MODE selector switch is in the NORM position.
(b) Make sure that the ENG/MASTER 1(2) control switch was in the OFF position not less than five minutes before you do this procedure.
(c) Put WARNING NOTICE(S) in position to tell persons not to operate:

The ENG/MODE selector switch, and
The ENG/MASTER 1(2) control switch.

(2) On the ENG section of maintenance panel 50VU:
(a) Make sure that the ON legend of the FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a WARNING NOTICE(S) in position to tell persons not to energize FADEC 1(2).
(3) Put an ACCESS PLATFORM 1M(3 FT) in position.
(4) Install a MAT - PROTECTIVE in the lower half of the inlet cowl.

4. Procedure
Subtask 72-21-44-020-050-A

A. Removal of the 18 Fan Disk Shields (1)
(1) Remove the fan blades (Ref. AMM TASK 72-21-20-000-801).
(2) Remove carefully the 18 fan disk shields (1) from the fan disk (2).

[Rev.10 from 2021] 2026.04.01 02:52:02 UTC