W DOC AIRBUS | AMM A320F

Removal of the Low Pressure Compressor (LPC) Stage 1 Inlet Guide Vane (IGV) [CFML]


TASK 72-21-21-000-801-A
Removal of the Low Pressure Compressor (LPC) Stage 1 Inlet Guide Vane (IGV)


WARNING: BE CAREFUL WHEN YOU DO WORK ON THE ENGINE PARTS AFTER THE ENGINE SHUTDOWN. USE APPLICABLE THERMAL GLOVES. THE ENGINE PARTS CAN STAY HOT FOR ONE HOUR AFTER SHUTDOWN AND CAN BURN YOU.
ZONE: 210
ZONE: 400
1. Reason for the Job
Self explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
1
ACCESS PLATFORM 1M(3 FT)
No specific
AR
WARNING NOTICE(S)
956A6880G01
1
SCREW SET, DISINSTALL - VANE LOW PRESSURE COMPRESSOR
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
210
CKPT,FWD COMPT BHD TO FLT COMPT BULKHEAD
400
POWER PLANT, NACELLES AND PYLONS
FOR [4020KM1] (POWER PLANT-DEMOUNTABLE, ENGINE 1)
437AL, 438AR
FOR [4020KM2] (POWER PLANT-DEMOUNTABLE, ENGINE 2)
447AL, 448AR
 C. Referenced Information
REFERENCE
DESIGNATION
TASK 71-13-00-010-803-A
Opening of the Fan Cowl Doors
TASK 72-21-02-000-802-A
Removal of the Flow Splitter
3. Job Set-up
Subtask 72-21-21-941-050-A
A. Safety Precautions
   (1) On the center pedestal, on ENG panel 115VU:
     (a) Make sure that the ENG/MODE selector switch is in the NORM position.
     (b) Make sure that the ENG/MASTER 1(2) control switch was in the OFF position not less than five minutes before you do this procedure.
     (c) Put WARNING NOTICE(S) in position to tell persons not to operate:
  • The ENG/MODE selector switch,
  • The ENG/MASTER 1(2) control switch.
   (2) On the ENG section of maintenance panel 50VU:
     (a) Make sure that the ON legend of the FADEC GND PWR/1(2) pushbutton switch is off.
     (b) Put a WARNING NOTICE(S) in position to tell persons not to energize FADEC 1(2).
Subtask 72-21-21-010-050-A
B. Get Access
   (1) Open the fan cowl doors (Ref. AMM TASK 71-13-00-010-803):
     (a) FOR [4020KM1] (POWER PLANT-DEMOUNTABLE, ENGINE 1)
437AL 438AR
     (b) FOR [4020KM2] (POWER PLANT-DEMOUNTABLE, ENGINE 2)
447AL 448AR
   (2) Put an ACCESS PLATFORM 1M(3 FT) in position.
4. Procedure
Subtask 72-21-21-020-050-A
A. Removal of the LPC Stage 1 IGV
   (1) POST SB 72-0080
Remove the ring rotating spacer (Ref. AMM D/O 72-21-25-00).
END OF POST SB 72-0080
   (2) Remove the flow splitter (2) (Ref. AMM TASK 72-21-02-000-802).
   (3) Loosen the nuts (5).
   (4) Remove the bolts (4) that attach the LPC stage 1 IGV (1) to the stage 2 booster vane assembly (3).
   (5) Remove the LPC stage 1 IGV (1) from the stage 2 booster vane assembly (3) using the 956A6880G01 SCREW SET, DISINSTALL - VANE LOW PRESSURE COMPRESSOR.
[Rev.10 from 2021] 2026.04.01 13:03:49 UTC