General Visual Inspection of the Fan Cowl Baulk Bracket [PW11]

TASK 71-13-10-210-801-A
General Visual Inspection of the Fan Cowl Baulk Bracket

WARNING: BE CAREFUL WHEN YOU DO WORK ON THE ENGINE AFTER SHUTDOWN. THE ENGINE CAN STAY HOT FOR A LONG TIME. IF YOU DO NOT OBEY THIS INSTRUCTION, INJURY CAN OCCUR.

WARNING: WEAR APPLICABLE PERSONAL PROTECTIVE EQUIPMENT (PPE) WHEN YOU DO THIS TASK. BEFORE YOU USE PPE, READ, UNDERSTAND AND OBEY ALL INSTRUCTIONS FOR ITS USE. THESE INSTRUCTIONS INCLUDE INSTRUCTIONS FROM THE MANUFACTURER, YOUR EMPLOYER AND GOVERNMENT REGULATIONS. YOU CAN GET INJURED IF YOU DO NOT USE PPE. GET INSTRUCTIONS FROM YOUR EMPLOYER ON WHICH PPE IS NECESSARY.

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
TASK 71-00-00-860-833-A	Procedure to Prevent Engine Motoring
TASK 71-13-10-300-801-A	Repair of the Fan Cowl Latch Baulk Bracket Assembly
Fan Cowl Baulk Bracket and Wear Strip

3. Job Set-up
Subtask 71-13-10-941-052-A ** ON A/C NOT FOR ALL

A. Safety Precautions
(1) Do the procedure to prevent engine motoring
(Ref. AMM TASK 71-00-00-860-833).

4. Procedure

CAUTION: WIPE CLEAN ALL PARTS AND TOOLS AS NECESSARY TO REMOVE UNWANTED DEBRIS AND PREVENT DAMAGE TO THE ENGINE.

Subtask 71-13-10-210-050-A ** ON A/C NOT FOR ALL

A. General Visual Inspection of the Fan Cowl Baulk Bracket
(1) Do not discard a part until you are sure there are no repairs available. If you reject a part and no repair is available, contact United Technologies Aerospace Systems (UTAS) for disposition.
(2) Find the baulk bracket assembly above the aft fan cowl latch on the left fan cowl door.
(3) Do a general visual inspection of the baulk bracket assembly:
(a) Examine the baulk bracket assembly. Look for gouges, cracks, holes, distortions, and other damage. If you find damage, replace the baulk bracket assembly (Ref. AMM TASK 71-13-10-300-801) or contact UTAS for disposition.
(b) Examine the pins, nuts and washers, if there, that attach the baulk bracket assembly. Look for cracks, gouges, too much wear, corrosion, correct assembly, and other damage. If you find damage, replace the damaged part (Ref. AMM TASK 71-13-10-300-801).
(c) For CONFIGURATION 1 and CONFIGURATION 2
1 Examine the wear strip on the baulk bracket assembly. Look for too much wear, distortions, cracks, holes, gouges, nicks, corrosion, delamination, disbonds, and other damage. If you find damage, replace the baulk bracket assembly (Ref. AMM TASK 71-13-10-300-801) or contact UTAS for disposition.

5. Close-up
Subtask 71-13-10-942-050-A ** ON A/C NOT FOR ALL

A. Close Access
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Remove the WARNING NOTICE(S).

[Rev.10 from 2021] 2026.04.01 02:32:28 UTC