Detailed Inspection of Vertical Stabilizer, Attach Fittings, Including Load Introduction Area at Skin Panels

TASK 55-36-00-210-001-A
Detailed Inspection of Vertical Stabilizer, Attach Fittings, Including Load Introduction Area at Skin Panels

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

WARNING: MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS SURFACES ARE CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE TO EQUIPMENT.

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

ZONE: 320
ZONE: 323

1. Reason for the Job
Refer to the MPD TASK: 553004-01
DETAILED INSPECTION OF VERTICAL STABILIZER, ATTACH FITTINGS, INCLUDING LOAD INTRODUCTION AREA AT SKIN PANELS
2. Job Set-up Information
A. Consumable Materials

REFERENCE	DESIGNATION
(Material No.08BAA9)	Non Aqueous Cleaner-General - -
(Material No.14SBA1)	Textile-Lint free Cotton -

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
320	VERTICAL STABILIZER AND RUDDER
323	VERTICAL STABILIZER SPAR BOX

C. Referenced Information

REFERENCE	DESIGNATION
TASK 53-55-11-000-001-A	Removal of the Vertical Stabilizer Fairings
TASK 53-55-11-400-001-A	Installation of the Vertical Stabilizer Fairings
SRM 55310001	(for corrective action)
Inspection Area

3. Job Set-up
Subtask 55-36-00-010-050-A

A. Get Access
(1) Remove the fairings 323AL and 323AR (Ref. AMM TASK 53-55-11-000-001).
(2) Carefully clean the inspection area with Non Aqueous Cleaner-General - - (Material No.08BAA9) and a Textile-Lint free Cotton - (Material No.14SBA1) .

4. Procedure
Subtask 55-36-00-210-050-A

A. Do a detailed visual inspection of the vertical stabilizer attach fittings including the load introduction area at the skin panels.

NOTE: If necessary, refer to the ASRM SRM 55310001 for the correct repair procedure.

5. Close-up
Subtask 55-36-00-410-050-A

A. Close Access
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Install the fairings 323AL and 323AR (Ref. AMM TASK 53-55-11-400-001).
(3) Remove the WARNING NOTICE(S).
(4) Remove the ground support and maintenance equipment, the special and standard tools and all other items.

[Rev.10 from 2021] 2026.04.01 03:59:45 UTC