Repair of Corroded Areas

TASK 51-74-11-300-001-A
Repair of Corroded Areas

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	CLOTH-EMERY (GRADE 400)
No specific	1	PAPER - MASKING
No specific	1	TAPE - MASKING

B. Consumable Materials

REFERENCE	DESIGNATION
(Material No.08ABC1)	Aqueous Cleaner-Aircraft Exterior Pressure Spraying -
(Material No.08BAA9)	Non Aqueous Cleaner-General - -
(Material No.14SBA1)	Textile-Lint free Cotton -
No specific	MAGNIFYING GLASS

C. Referenced Information

REFERENCE	DESIGNATION
TASK 51-75-12-300-001-A	Repair of Major Paint Damage on Light Alloy and Composite Material
TASK 51-76-11-300-001-A	Repair of the Sealing

3. Job Set-up
Subtask 51-74-11-941-050-A

A. Get access to the area of the corrosion.

4. Procedure
Subtask 51-74-11-140-050-A

A. Repair of Corrosion
(1) Clean the repair area with Aqueous Cleaner-Aircraft Exterior Pressure Spraying - (Material No.08ABC1) and a Textile-Lint free Cotton - (Material No.14SBA1) .

WARNING: DO NOT APPLY ADHESIVE TAPE ON THE PROBES, DUCTS, SENSORS (STATIC, PITOT, TAT, AOA). USE ONLY THE SPECIFIED TOOLS FOR THE PROTECTION OF THE AIRCRAFT. THE SPECIFIED TOOLS:

GIVE THE CORRECT PROTECTION TO THE AIRCRAFT EQUIPMENT,
ARE EASY TO SEE FROM THE GROUND,
ARE EASY TO REMOVE.

IF YOU USE TAPE, THERE IS A RISK THAT SOME TAPE, OR ADHESIVE FROM THE TAPE, WILL STAY ON THE PROBES, DUCTS OR SENSORS. THIS CAN CAUSE INCORRECT INDICATIONS ON THE RELATED COCKPIT INSTRUMENTS.

(2) Cover the area adjacent to the damage with PAPER - MASKING and TAPE - MASKING.
(3) Remove the corrosion with CLOTH-EMERY (GRADE 400).

NOTE: For limits refer to the related ASRM-chapter.

(4) Clean the repair area with Non Aqueous Cleaner-General - - (Material No.08BAA9) and a lint-free cloth.
(5) Make a visual inspection with a MAGNIFYING GLASS to make sure that all the corrosion is removed.
(6) If necessary, repair the damaged sealant (Ref. AMM TASK 51-76-11-300-001).
(7) Repair the damaged paint (Ref. AMM TASK 51-75-12-300-001).

5. Close-up
Subtask 51-74-11-942-050-A

A. Removal of Equipment
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Remove the ground support and maintenance equipment, the special and standard tools and all other items.
(3) Make an entry in the aircraft log book and attach a tag on the captain side stick to tell the crew that:

Protection covers/devices have been installed.

[Rev.10 from 2021] 2026.04.01 01:34:28 UTC