W DOC AIRBUS | AMM A320F

Reactivation of the Runway Turnoff Light


TASK 33-43-00-440-002-A
Reactivation of the Runway Turnoff Light


WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:
  • THE FLIGHT CONTROLS
  • THE FLIGHT CONTROL SURFACES
  • THE LANDING GEAR AND THE RELATED DOORS
  • COMPONENTS THAT MOVE.
MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.
ZONE: 711
FIN: 3LC1
FIN: 3LC2
1. Reason for the Job
CDL 33-08
Turn OFF Light Lamp 3LC1, 3LC2
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
1
WARNING NOTICE(S)
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
711
NOSE GEAR
 C. Referenced Information
REFERENCE
DESIGNATION
TASK 33-43-11-400-001-A
Installation of the Runway Turnoff Light
TASK 33-43-11-960-002-A
Replacement of the Lamp of the Runway Turnoff Light
TASK 33-43-11-960-802-A
Replacement of the Lens of the Runway Turnoff Light for the LED Technology
3. Job Set-up
Subtask 33-43-00-941-052-A
A. Safety Precautions
   (1) Put a WARNING NOTICE(S) in position on the EXT LT section of the overhead panel 25VU to tell persons not to operate the runway turnoff lights.
Subtask 33-43-00-865-055-A
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged:
PANELDESIGNATIONFINLOCATION
** ON A/C ALL
FOR FIN: 3LC1 (LTRUNWAY TURNOFF, L)
122VULIGHTING/EXT LT/RWY TURN OFF/L1LC1W06
FOR FIN: 3LC2 (LTRUNWAY TURNOFF, R)
122VULIGHTING/EXT LT/RWY TURN OFF/R1LC2W05
4. Procedure
Subtask 33-43-00-440-050-A ** ON A/C NOT FOR ALL
A. Reactivation of the Runway Turnoff Light(s) (3LC1 and/or 3LC2)
   (1) If you removed the defective runway turnoff light(s) during the deactivation procedure:
     (a) Install the runway turnoff light(s) (Ref. AMM TASK 33-43-11-400-001).
     (b) Remove the placard on switch 4LR of panel 25VU.
   (2) If you repaired the glass lens of the runway turnoff light(s):
     (a) Remove the tape cover from the runway turnoff light(s).
     (b) Replace the lens of the runway turnoff light(s) (Ref. AMM TASK 33-43-11-960-002).
Subtask 33-43-00-440-050-B ** ON A/C NOT FOR ALL
A. Reactivation of the Runway Turnoff Light(s) (3LC1 and/or 3LC2)
   (1) If you removed the defective runway turnoff light(s) during the deactivation procedure:
     (a) Install the runway turnoff light(s) (Ref. AMM TASK 33-43-11-400-001).
     (b) Remove the placard on switch 4LR of panel 25VU.
   (2) If you repaired the glass lens of the runway turnoff light(s):
     (a) Remove the tape cover from the runway turnoff light(s).
     (b) Replace the lens of the runway turnoff light(s) (Ref. AMM TASK 33-43-11-960-802).
5. Close-up
Subtask 33-43-00-865-056-A
A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):
PANELDESIGNATIONFINLOCATION
** ON A/C ALL
FOR FIN: 3LC1 (LTRUNWAY TURNOFF, L)
122VULIGHTING/EXT LT/RWY TURN OFF/L1LC1W06
FOR FIN: 3LC2 (LTRUNWAY TURNOFF, R)
122VULIGHTING/EXT LT/RWY TURN OFF/R1LC2W05
Subtask 33-43-00-942-053-A
B. Put the aircraft back to its initial configuration.
   (1) Make sure that the work area is clean and clear of tools and other items.
   (2) Remove the WARNING NOTICE(S).
[Rev.10 from 2021] 2026.04.01 00:55:29 UTC