Removal of the Servicing Plate Kit

TASK 32-51-42-000-802-A
Removal of the Servicing Plate Kit

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

FIN: 2880GM

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	SAFETY BARRIER(S)
No specific	AR	SPATULA - NON METALLIC
No specific	AR	WARNING NOTICE(S)

B. Referenced Information

REFERENCE	DESIGNATION
TASK 32-00-00-481-001-A	Installation of the Safety Devices on the Landing Gears
Nose Landing Gear - Servicing Plate Kit ** ON A/C NOT FOR ALL

3. Job Set-up
Subtask 32-51-42-941-058-A ** ON A/C NOT FOR ALL

A. Safety Precautions
(1) Install the safety devices on the landing gear (Ref. AMM TASK 32-00-00-481-001).
(2) Put the WARNING NOTICE(S) in position:

In the cockpit, on panel 400VU, to tell persons no to operate the landing-gear control lever
On the steering handwheel (CAPT and F/O) and on the brake pedals, to tell persons no to operate them.

(3) Put the SAFETY BARRIER(S) in position.

4. Procedure
Subtask 32-51-42-020-056-A ** ON A/C NOT FOR ALL

A. Removal of the Servicing Plate Kit
(1) Carefully remove the servicing plate kit with a SPATULA - NON METALLIC.

Subtask 32-51-42-916-050-A ** ON A/C NOT FOR ALL

B. Repair of the Surface Protection
(1) If the surface protection of the steering cylinder (2) is damaged (removed paint or scratches), repair it.
(a) Cadmium plating:

Refer to the instructions given in the leg structure repair-section of the CMM.

(b) Paint:

Refer to the instructions given in the leg structure repair-section of the CMM.

[Rev.10 from 2021] 2026.04.01 00:51:48 UTC