Removal of the Link and Fitting Assemblies of the NLG Leg Door

TASK 32-22-15-000-802-A
Removal of the Link and Fitting Assemblies of the NLG Leg Door

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

ZONE: 711

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	SAFETY BARRIER(S)
No specific	AR	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
711	NOSE GEAR

C. Referenced Information

REFERENCE	DESIGNATION
TASK 32-22-15-000-001-A	Removal of the NLG Leg Door-Assembly
Link and Fitting Assemblies of the NLG Leg Door

3. Job Set-up
Subtask 32-22-15-941-054-A

A. Safety Precautions
(1) As necessary, use the applicable SAFETY BARRIERS, specified by the operator's instructions and your local regulations.
(2) In the cockpit, on the right-center instrument panel (400VU):

Put the WARNING NOTICE(S) in position to tell persons not to operate the landing-gear control lever.

(3) In the cockpit, on the steering handwheels (CAPT and F/O) and on the brake pedals:

Put the WARNING NOTICE(S) in position to tell persons not to operate the steering handwheels (CAPT and F/O) and the brake pedals.

Subtask 32-22-15-010-051-A

B. Get Access
(1) Remove the NLG leg door-assembly (Ref. AMM TASK 32-22-15-000-001).

4. Procedure
Subtask 32-22-15-020-053-A

A. Removal of the Link and Fitting Assemblies of the NLG Leg Door
(1) Remove the link assembly (4) as follows:
(a) Remove and discard the cotter pin (1).
(b) Remove the nut (2), the washer (3) and the bolt (5).
(c) Remove the link assembly (4) from the NLG leg (6).
(2) Remove the fitting assembly (7) as follows:
(a) Remove and discard the cotter pin (13).
(b) Remove the nut (12), the washer (11), the bolt (10), the washers (17) and the bush (9).
(c) Remove and discard the cotter pin (16).
(d) Remove the nut (15), the washer (14) and the bolt (8).
(e) Remove the fitting assembly (7) from the NLG leg (6).

[Rev.10 from 2021] 2026.04.01 00:43:25 UTC