Restoration of the A/C after flight without NLG Leg Door Assy

TASK 32-22-00-440-003-A
Restoration of the A/C after flight without NLG Leg Door Assy

1. Reason for the Job
CDL 52-11
Nose Landing Gear Leg Door (712)
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	SAFETY BARRIER(S)

B. Consumable Materials

REFERENCE	DESIGNATION
(Material No.14QFB1)	Wire-Locking Dia: 0.8 mm CRES Nickel Alloy -

C. Referenced Information

REFERENCE	DESIGNATION
TASK 32-22-15-400-001-A	Installation of the NLG Leg Door-Assembly

3. Job Set-up
Subtask 32-22-00-860-058-A

A. Safety Precautions
(1) Put the SAFETY BARRIER(S) in position.

4. Procedure
Subtask 32-22-00-420-052-A

A. Installation of the NLG Leg Door
(1) Install the NLG leg door and all the attaching parts (Ref. AMM TASK 32-22-15-400-001).

Subtask 32-22-00-980-051-A

B. Manual Operation

WARNING: USE PROTECTIVE GOGGLES AND GLOVES WHEN YOU REMOVE OR INSTALL LOCKWIRE. EACH TIME YOU CUT LOCKWIRE, REMOVE AND DISCARD IT IMMEDIATELY. LOOSE LOCKWIRE CAN CUT YOU OR MAKE YOU BLIND, AND/OR CAN CAUSE DAMAGE.

(1) In the avionics compartment on the panel 188VU:
(a) Set the L/G DOWN VMO/MMO SELECTION switch 22FP to NORM.
(b) Lock the safety cover and secure it with 14QFB1Wire-Locking Dia: 0.8 mm CRES Nickel Alloy -.

5. Close-up
Subtask 32-22-00-860-059-A

A. Put the aircraft back to its initial configuration.
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Remove the ground support and maintenance equipment, the special and standard tools and all other items.

[Rev.10 from 2021] 2026.04.01 00:43:02 UTC