Removal of the Thermostat

TASK 30-72-11-000-001-A
Removal of the Thermostat

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 2M (6 FT)
No specific	1	ELEC CONTACTS INSERTION EXTRACTION TOOL M15570-20
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	1	SCREWDRIVER

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
161DW, 171AL

C. Referenced Information

REFERENCE	DESIGNATION
TASK 24-42-00-861-001-A	Energize the Ground Service Network from the External Power
TASK 25-55-12-000-001-A	Removal of the Aft Cargo-Compartment Partition at FR65
TASK 52-30-00-860-001-A	Open the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump
Thermostat 12DV and Thermostat 14DV ** ON A/C NOT FOR ALL
Thermostat 12DV ** ON A/C NOT FOR ALL

3. Job Set-up
Subtask 30-72-11-861-052-A ** ON A/C NOT FOR ALL

A. Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).

Subtask 30-72-11-865-053-A ** ON A/C NOT FOR ALL

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
2001VU	POT/WASTE WIP-SVCE-PNL	15DV	D01
** ON A/C NOT FOR ALL
2001VU	POT WIP-SVCE-PNL	15DV	D01

Subtask 30-72-11-010-050-A ** ON A/C NOT FOR ALL

C. Get Access
(1) Put an ACCESS PLATFORM 2M (6 FT) in position at potable-water service panel 171AL.
(2) Open the panel and make sure that the drain-control handle is in the NORM position.
(3) Put an ACCESS PLATFORM 2M (6 FT) in position at the aft cargo-compartment door.
(4) Open the aft cargo-compartment door (Ref. AMM TASK 52-30-00-860-001).
(5) Remove partition 161DW to get access to the thermostat and terminal block 7510VT (Ref. AMM TASK 25-55-12-000-001).

4. Procedure
Subtask 30-72-11-020-050-A ** ON A/C NOT FOR ALL

A. Removal of the Thermostat
(1) Remove and discard the cable ties from the electrical wires.
(2) Make match marks on all electrical wires before you disconnect them.

CAUTION: MAKE SURE THAT THE ELECTRICAL CONNECTORS ARE CLEAN BEFORE YOU DISCONNECT OR CONNECT THEM. CONTAMINATION ON THE ELECTRICAL CONNECTORS CAN CAUSE DAMAGE TO EQUIPMENT.

(3) Disconnect the electrical connections (8) with the ELEC CONTACTS INSERTION EXTRACTION TOOL M15570-20 from terminal block 7510VT.
(4) Remove the screws (4), the washer (2) and the nut (1).
(5) Lift the thermostat-housing cover (3).
(6) Loosen the threaded-sleeve (7) with a SCREWDRIVER.
(7) Remove the threaded-sleeve (7).
(8) Remove the thermostat-housing (6) from the stud (5).

[Rev.10 from 2021] 2026.04.01 08:23:37 UTC