W DOC AIRBUS | TSM A320F

Failure of the Starter Shutoff Valve on Engine 2


TASK 80-00-00-810-836-A
Failure of the Starter Shutoff Valve on Engine 2


1. Possible Causes
  • aircraft wiring
  • EIU-2 [1KS2]
  • CTL SW-ENG/MASTER 2 [2KC]
  • SEL SW-ENG/MODE/CRANK/AUTO IGN/IGN [6KS]
  • ECU [4000KS]
2. Job Set-up Information
 A. Referenced Information
REFERENCE
DESIGNATION
ESPM 204521
AMM 31-10-00-700-001
Test Program after Removal/Installation of a VU panel
AMM 71-00-00-710-003
Engine Automatic Start
AMM 73-21-60-000-001
Removal of the Electronic Control Unit (ECU)
AMM 73-21-60-400-001
Installation of the Electronic Control Unit (ECU)
AWM 732509
AMM 73-25-34-000-040
Removal of the Engine Interface Unit (EIU)
AMM 73-25-34-400-040
Installation of the Engine Interface Unit (EIU)
ASM 743101
3. Fault Confirmation
Subtask 80-00-00-710-123-A ** ON A/C NOT FOR ALL
A. Test
   (1) Not applicable, the fault is evident.
4. Fault Isolation
Subtask 80-00-00-810-098-A ** ON A/C NOT FOR ALL
A. If the fault symptom is identified by the crew observation: ENG2 STARTING - Opening of the starter shutoff valve not possible in automatic mode.
   (1) Remove the panel 115VU and do a check and repair the aircraft wiring between:
  • The ENG/MASTER2 control switch (2KC) and the EIU2 (1KS2), pins AA/5A, 4E to pins 2A, 3A
  • The ENG/MODE/CRANK/AUTO IGN/IGN selector switch (6KS) and the EIU2 (1KS2), pins AA/1A, 1B, 1C to pins 22, 23, 24.
   (2) Do a check and repair the aircraft wiring between the EIU2 (1KS2) and the ECU (4000KS) ASM 743101.
   (3) If the fault continues:
   (4) If the fault continues:
   (5) If the fault continues:
Subtask 80-00-00-810-099-A ** ON A/C NOT FOR ALL
B. If the starter shutoff valve does not open in manual mode:
   (1) Do a check and repair the aircraft wiring between the ENG/MAN START/2 pushbutton switch (9KS2) and the EIU2 (1KS2), pin AA/1F to pin AA3.
   (2) Do a check and repair the aircraft wiring between the EIU2 (1KS2) and the ECU (4000KS) ASM 743101.
   (3) If the fault continues:
   (4) If the fault continues:
  • Replace the CTL SW-ENG/MASTER 2 [2KC] and/or
  • Replace the SEL SW-ENG/MODE/CRANK/AUTO IGN/IGN [6KS] .
   (5) If the fault continues:
Subtask 80-00-00-710-124-A ** ON A/C NOT FOR ALL
C. Do an engine automatic start procedure AMM 71-00-00-710-003.
[Rev.8 from Aug 2018] 2026.04.04 04:38:38 UTC