W DOC AIRBUS | TSM A320F

Failure of the Starter Shutoff Valve on Engine 1


TASK 80-00-00-810-835-A
Failure of the Starter Shutoff Valve on Engine 1


1. Possible Causes
  • aircraft wiring
  • EIU-1 [1KS1]
  • CTL SW-ENG/MASTER 1 [3KC]
  • SEL SW-ENG/MODE/CRANK/AUTO IGN/IGN [6KS]
  • ECU [4000KS]
2. Job Set-up Information
 A. Referenced Information
REFERENCE
DESIGNATION
ESPM 204521
AMM 31-10-00-700-001
Test Program after Removal/Installation of a VU panel
AMM 71-00-00-710-003
Engine Automatic Start
AMM 73-21-60-000-001
Removal of the Electronic Control Unit (ECU)
AMM 73-21-60-400-001
Installation of the Electronic Control Unit (ECU)
AWM 732509
AMM 73-25-34-000-040
Removal of the Engine Interface Unit (EIU)
AMM 73-25-34-400-040
Installation of the Engine Interface Unit (EIU)
ASM 743101
3. Fault Confirmation
Subtask 80-00-00-710-121-A ** ON A/C NOT FOR ALL
A. Test
   (1) Not applicable, the fault is evident.
4. Fault Isolation
Subtask 80-00-00-810-096-A ** ON A/C NOT FOR ALL
A. If the fault symptom is identified by the crew observation : ENG1 STARTING - opening of the starter shutoff valve not possible in automatic mode:
   (1) Remove the panel 115VU and do a check and repair the aircraft wiring between:
  • the ENG/MASTER 1 control switch (3KC) and the EIU1 (1KS1), pins AA/5A, 4E to pins 2A, 3A
  • the ENG/MODE/CRANK/AUTO IGN/IGN selector switch (6KS) and the EIU1 (1KS1), pins AA/1A, 1B, 1C to pins 2, 3, 4.
   (2) Do a check and repair the aircraft wiring between the EIU1 (1KS1) and the ECU (4000KS) ASM 743101.
   (3) If the fault continues:
   (4) If the fault continues:
   (5) If the fault continues:
Subtask 80-00-00-810-097-A ** ON A/C NOT FOR ALL
B. If the starter shutoff valve does not open in manual mode:
   (1) Do a check and repair the aircraft wiring between the ENG/MAN START/1 pushbutton switch (9KS1) and the EIU1 (1KS1), pin AA/1F to pin AA3.
   (2) Do a check and repair the aircraft wiring between the EIU1 (1KS1) and the ECU (4000KS) ASM 743101.
   (3) If the fault continues:
   (4) If the fault continues:
  • replace the CTL SW-ENG/MASTER 1 [3KC] and or
  • replace the SEL SW-ENG/MODE/CRANK/AUTO IGN/IGN [6KS] .
   (5) If the fault continues:
Subtask 80-00-00-710-122-A ** ON A/C NOT FOR ALL
C. Do an engine automatic start procedure AMM 71-00-00-710-003.
[Rev.8 from Aug 2018] 2026.04.04 04:38:38 UTC