Operation Time for the Starter More Than the Limits, on Engine 1 or 2

TASK 80-00-00-810-831-A
Operation Time for the Starter More Than the Limits, on Engine 1 or 2

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
AMM 71-00-00-710-003	Engine Automatic Start
AMM 73-21-60-000-001	Removal of the Electronic Control Unit (ECU)
AMM 73-21-60-400-001	Installation of the Electronic Control Unit (ECU)
AMM 73-29-00-710-040	Operational Test of the FADEC on the ground (with Engine Motoring)
AMM 80-11-10-000-001	Removal of the Pneumatic Starter
AMM 80-11-10-000-002	Removal of the Pneumatic Starter
AMM 80-11-10-400-001	Installation of the Pneumatic Starter
AMM 80-11-10-400-002	Installation of the Pneumatic Starter
AMM 80-11-20-000-001	Removal of the Starter Shutoff Valve
AMM 80-11-20-400-001	Installation of the Starter Shutoff Valve

3. Fault Confirmation
Subtask 80-00-00-710-113-A ** ON A/C NOT FOR ALL

A. Test
(1) Do the operational test of the FADEC on the ground (wirh engine non motoring) AMM 73-29-00-710-040.

4. Fault Isolation
Subtask 80-00-00-810-092-A ** ON A/C NOT FOR ALL

A. If the test does not give a maintenance message:

on the lower ECAM display unit, do a check for low pressure in the starter air duct (at least 30 PSIG)
replace the pneumatic starter AMM 80-11-10-000-001 and AMM 80-11-10-400-001.

(1) If te fault continues:

(2) If the fault continues:

Subtask 80-00-00-810-092-B ** ON A/C NOT FOR ALL

A. If the test does not give a maintenance message:

on the lower ECAM display unit, do a check for low pressure in the starter air duct (at least 30 PSIG)
replace the pneumatic starter AMM 80-11-10-000-002 and AMM 80-11-10-400-002.

(1) If the fault continues:

Subtask 80-00-00-710-114-A ** ON A/C NOT FOR ALL

B. Do an engine automatic start procedure AMM 71-00-00-710-003.

[Rev.8 from Aug 2018] 2026.04.04 04:38:37 UTC