DOC AIRBUS | TSM A320FOil Quantity of Engine 2 decreases faster than on the other Engine
1. Possible Causes
· oil leaks
· oil scavenge pump
· INDICATOR-POS, NO.4 SCAVENGE VALVE ( 4006EN )
· seal assembly
· XMTR-OIL QTY ( 4002EN )
2 Job Set-up Information
A. Referenced Information
REFERENCE DESIGNATION
Ref. AMM 12-13-79-610-011 Check Oil Level and Replenish
Ref. AMM 71-00-00-710-012 Test No.3 : Idle Leak Check
Ref. AMM 71-13-00-010-010 Opening of the Fan Cowls 437AL(447AL),438AR(448AR)
Ref. AMM 71-13-00-410-010 Closing of the Fan Cowls 437AL(447AL),438AR(448AR)
Ref. AMM 72-60-31-000-010 Removal of the Seal Assembly
Ref. AMM 72-60-31-400-010 Installation of the Seal Assembly
Ref. AMM 78-32-00-010-010 Opening of the Thrust Reverser Halves
Ref. AMM 78-32-00-410-010 Closing of the Thrust Reverser Halves
Ref. AMM 79-00-00-200-011 Inspection of the Magnetic Chip Detectors for Debris
Ref. AMM 79-00-00-200-012 Inspection of the Oil Filters
Ref. AMM 79-20-00-200-010 General Visual Inspection of the Oil Distribution System Components,
Tubes and Joints
Ref. AMM 79-21-43-200-010 Inspection of the Fuel Cooled Oil Cooler for Internal Leakage
Ref. AMM 79-22-41-000-010 Removal of the Scavenge Oil Pump
Ref. AMM 79-22-41-400-010 Installation of the Scavenge Oil Pump
Ref. AMM 79-23-51-000-010 Removal of the No. 4 Bearing Compartment Scavenge Valve
Ref. AMM 79-23-51-400-010 Installation of the No. 4 Bearing Compartment Scavenge Valve
Ref. AMM 79-31-15-000-010 Removal of the Oil Quantity Transmitter
Ref. AMM 79-31-15-400-010 Installation of the Oil Quantity Transmitter
3. Fault Confirmation
Subtask 79-31-00-710-077-A
A. Test
Not applicable.
4. Fault Isolation
Subtask 79-31-00-810-069-A
A. If the fault symptom is identified by the crew observation: ENG2-Oil quantity decreases faster than on the
other engine:
· do a check of the engine oil quantity Ref. AMM 12-13-79-610-011 .
(1) If the oil level shows that the engine used too much oil:
(a) Examine the engine inlet, cold stream duct and exhaust for signs of oil leaks :
1 If you find oil:
· do an inspection of the magnetic chip detectors Ref. AMM 79-00-00-200-011
· do an inspection of the oil filters Ref. AMM 79-00-00-200-012 .
a If you find contamination:
· reject the engine 2.
b If you find no contamination:
· replace the oil scavenge pump Ref. AMM 79-22-41-000-010 and Ref.
AMM 79-22-41-400-010 .
(b) Examine the breather outlet:
1 If you find sign of excessive oil:
· replace the INDICATOR-POS, NO.4 SCAVENGE VALVE ( 4006EN ) Ref.
AMM 79-23-51-000-010 and Ref. AMM 79-23-51-400-010
· replace the seal assembly Ref. AMM 72-60-31-000-010 and Ref.
AMM 72-60-31-400-010 .
(c) Open the fan cowls 447AL and 448AR Ref. AMM 71-13-00-010-010 .
(d) Open the thrust reverser cowls 461AL and 462AR Ref. AMM 78-32-00-010-010 .
(e) Examine the engine installation for signs of oil leaks Ref. AMM 79-20-00-200-010 :
1 repair as necessary.
(f) If you find no fault:
· replace the oil scavenge pump Ref. AMM 79-22-41-000-010 and Ref.
AMM 79-22-41-400-010 .
· examine the Fuel Cooled Oil Cooler (6003EM) for internal leakage Ref.
AMM 79-21-43-200-010 .
(2) If the oil level shows that the engine used a normal quantity of oil:
(a) Do a check to see if the oil quantity indication on the ENG page of the ECAM upper display unit
agrees with the oil tank contents.
1 If the two indications do not agree:
a Replace the XMTR-OIL QTY ( 4002EN ) Ref. AMM 79-31-15-000-010 and Ref.
AMM 79-31-15-400-010 .
2 If you find no fault:
a Replace the oil scavenge pump Ref. AMM 79-22-41-000-010 and Ref.
AMM 79-22-41-400-010 .
5. Close-up
Subtask 79-31-00-860-057-A
A. Put the aircraft back to its initial configuration.
(1) Make sure that the thrust reverser halves 461AL and 462AR are closed Ref.
AMM 78-32-00-410-010 .
(2) Make sure that the fan cowls 447AL and 448AR are closed Ref. AMM 71-13-00-410-010 .
Subtask 79-31-00-710-083-A
B. Make sure that the fault has been corrected :
(1) Do an idle leak check Ref. AMM 71-00-00-710-012 .
79-32 - (IAE) - OIL TEMPERATURE INDICATING SYSTEM
79-32-00 - (IAE) - OIL TEMPERATURE INDICATING SYSTEM
79-32-00 PB 201 CONF 13 - OIL TEMPERATURE
INDICATING SYSTEM - FAULT ISOLATION PROCEDURES [Rev.6 from Feb 2017] 2026.04.04 04:38:28 UTC