Misalignment between the two Throttle Control Levers at Idle Stop Position

---

1. Possible Causes
2 Job Set-up Information
A. Referenced Information
REFERENCE DESIGNATION
Ref. AMM 76-11-41-000-041 Removal of the Throttle Control Lever Assembly
Ref. AMM 76-11-41-400-041 Installation of the Throttle Control Lever Assembly
3. Fault Confirmation
Subtask 76-11-00-710-071-A
A. Test
Not applicable
4. Fault Isolation
Subtask 76-11-00-810-063-A
A. If the fault symptom is identified by the crew observation ENG-Misalignment between the two throttle
control levers at idle stop position (clearance 2 to 3 degrees):
· inspect and replace, as necessary, the bearing (IDLE stop) Ref. AMM 76-11-41-000-041 and Ref.
AMM 76-11-41-400-041 . [Rev.6 from Feb 2017] 2026.04.04 04:37:28 UTC