DOC AIRBUS | TSM A320FIDG Oil Overtemperature on Engine 2
1. Possible Causes
· fuel cooled IDG oil cooler
· IDG ( 4000XU )
· EEC ( 4000KS )
2 Job Set-up Information
A. Referenced Information
REFERENCE DESIGNATION
Ref. AMM 24-21-42-000-010 Removal of the Fuel-Cooled IDG Oil-Cooler
Ref. AMM 24-21-42-400-010 Installation of the Fuel-Cooled IDG Oil-Cooler
Ref. AMM 24-21-51-000-010 Removal of the Integrated Drive Generator -IDG 1(2)
Ref. AMM 24-21-51-400-010 Installation of the Integrated Drive Generator -IDG 1(2)
Ref. AMM 73-22-34-000-010 Removal of the Electronic Engine Control (EEC)
Ref. AMM 73-22-34-400-010 Installation of the Electronic Engine Control (EEC)
3. Fault Confirmation
Subtask 73-22-00-710-076-A
A. Test
Not applicable, the fault may not be evident on the ground.
4. Fault Isolation
PRE SB 28-1100 for A/C 0101-0101
Subtask 73-22-00-810-063-A
A. If the fault symptom is identified by the CFDS message HMS-IDG OIL OVTMP 2 and the ECAM warning
ENG 2 FADEC:
· replace the fuel cooled IDG oil cooler Ref. AMM 24-21-42-000-010 and Ref. AMM 24-21-42-400-010 .
(1) If the fault continues:
· replace the IDG ( 4000XU ) Ref. AMM 24-21-51-000-010 and Ref. AMM 24-21-51-400-010 .
(2) If the fault continues:
· replace the EEC ( 4000KS ) Ref. AMM 73-22-34-000-010 and Ref. AMM 73-22-34-400-010 .
** ON A/C
POST SB 28-1100 for A/C 0101-0101
Subtask 73-22-00-810-063-B
A. If the Fault Symptom is Identified by the CFDS Message HMS-IDG OIL OVTMP 2 and the ECAM Warning
ENG 2 FADEC
· replace the fuel cooled IDG oil cooler Ref. AMM 24-21-42-000-010 and Ref. AMM 24-21-42-400-010 .
(1) If the fault continues:
· Replace the IDG ( 4000XU ) Ref. AMM 24-21-51-000-010 and Ref. AMM 24-21-51-400-010 .
(2) If the fault continues:
· Replace the EEC ( 4000KS ) Ref. AMM 73-22-34-000-010 and Ref. AMM 73-22-34-400-010 .
(3) If the fault continues:
· Inspect the wing tank temperature dummy load resistors (41QJ and 42QJ for the correct value)
(Ref. SB 28-1100).
Subtask 73-22-00-710-077-A
B. After the subsequent flight, make sure that the fault does not continue. [Rev.6 from Feb 2017] 2026.04.04 04:36:16 UTC