W DOC AIRBUS | TSM A320F

Fault of the Cockpit Door Lock System -OPEN Lamp stays ON


TASK 52-51-00-810-803-A
Fault of the Cockpit Door Lock System -OPEN Lamp stays ON


1. Possible Causes
  • ELECTRICAL STRIKE-CTR [31MQ]
  • CONTROL UNIT-COCKPIT DOOR LOCKING SYSTEM or CONTROL UNIT-COCKPIT DOOR LOCKING SYSTEM [24MQ]
  • ANN LT switch 33LP
  • RELAY-TEST DC 61LP
2. Job Set-up Information
 A. Referenced Information
REFERENCE
DESIGNATION
ASM 331402
AMM 52-51-00-710-001
Operational Test of the Routine Access
AMM 52-51-00-820-001
Adjustment of the Cockpit Door, Electrical Release Strikes and Latch Mechanisms
ASM 525102
AMM 52-51-12-000-001
Removal of the Electrical Release Strike
AMM 52-51-12-400-001
Installation of the Electrical Release Strike
AMM 52-51-14-000-001
Removal of the Control Unit of the Cockpit-Door Locking System
AMM 52-51-14-400-001
Installation of the Control Unit of the Cockpit-Door Locking System
3. Fault Confirmation
Subtask 52-51-00-710-053-A
A. Test
   (1) Do the test of the Electrical Door-Release System AMM 52-51-00-710-001.
4. Fault Isolation
Subtask 52-51-00-810-057-A
A. If the OPEN lamp of the indication light 22MQ at the COCKPIT DOOR panel 119 VU stays on and the cockpit door is closed and locked:
   (1) If the adjustment of the ELECTRICAL STRIKE-CTR [31MQ] is correct:
  • do a check for continuity between the ELECTRICAL STRIKE-CTR [31MQ] cable No.4 and cable No.7.
   (2) If there is continuity:
   (3) If there is no continuity:
  • do a check for continuity between the ELECTRICAL STRIKE-CTR [31MQ] cable No.7 and CONTROL UNIT-COCKPIT DOOR LOCKING SYSTEM or CONTROL UNIT-COCKPIT DOOR LOCKING SYSTEM [24MQ] connector A/H ASM 525102.
     (a) If there is no continuity:
  • do a check and repair the wiring between the ELECTRICAL STRIKE-CTR [31MQ] and the CONTROL UNIT-COCKPIT DOOR LOCKING SYSTEM or CONTROL UNIT-COCKPIT DOOR LOCKING SYSTEM [24MQ] ASM 525102.
     (b) If there is continuity:
  • make sure that the ANN LT switch 33LP is in BRT position
  • do a check for GND signal at:
    the RELAY-TEST DC 61LP connector AA ASM 331402
       1 If there is no ground signal:
  • replace the RELAY-TEST DC 61LP
       2 If there is a ground signal:
5. Close-up
Subtask 52-51-00-710-054-A
A. Test
   (1) Do the test given in Para.3.
[Rev.8 from Aug 2018] 2026.04.04 04:34:55 UTC