Low Bleed Temperature of ENG 2 in Cruise

TASK 36-11-00-810-A45-A
Low Bleed Temperature of ENG 2 in Cruise

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
AMM 36-11-00-740-802	BITE Test of the Engine Bleed Air System (EBAS) (System Test)
ASM 361102
AMM 36-11-17-000-001	Removal of the Heat-Exchanger Outlet-Temperature Sensor
AMM 36-11-17-400-001	Installation of the Heat-Exchanger Outlet-Temperature Sensor
AMM 36-11-54-000-803	Removal of the Fan Air Valve (FAV)
AMM 36-11-54-400-803	Installation of the Fan Air Valve (FAV)
AMM 36-11-54-720-804	Functional Test of the Opening of the Fan Air Valve with the Bleed Test Set P/N 98D36109001000

3. Fault Confirmation
Subtask 36-11-00-710-517-A ** ON A/C NOT FOR ALL

A. Test
(1) Do the BITE test EBAS AMM 36-11-00-740-802.

4. Fault Isolation
Subtask 36-11-00-810-502-A ** ON A/C NOT FOR ALL

A. If the BITE test gives no maintenance message:

(1) If the BITE test gives the class 3 maintenance message:
TEMP SENSOR 6HA2

Replace the SENSOR-EXCHANGER OUT TEMP, ENG 2 [6HA2] AMM 36-11-17-000-001 and AMM 36-11-17-400-001.

Subtask 36-11-00-810-533-A ** ON A/C NOT FOR ALL

B. If the fault continues:
(1) Do a check of the wiring ASM 361102 between:

Engine 2 Exchanger Output Temperature Sensor (6HA2) pin A/1 and pin A/2 and BMC-2 (1HA2) pin AA/2C and pin AA/2B.
Engine 2 Exchanger Output Temperature Sensor (6HA2) pin B/1 and pin B/2 and BMC-2 (1HA2) pin AB/7D and pin AB/7E.

(a) If the wiring is not correct:

(b) If the wiring is correct:
1 Do a functional test of the fan air valve AMM 36-11-54-720-804.
a If the test is not OK:

Subtask 36-11-00-710-518-A ** ON A/C NOT FOR ALL

C. After the subsequent flight, make sure that the fault does not continue.

[Rev.8 from Aug 2018] 2026.04.04 04:33:58 UTC