DOC AIRBUS | TSM A320FLoss of the Two Sensing Elements of the Exchanger Outlet Temperature-Sensor of the Engine 1
TASK 36-11-00-810-827-A
Loss of the Two Sensing Elements of the Exchanger Outlet Temperature-Sensor of the Engine 1
1. Possible Causes
A. Referenced Information
3. Fault Confirmation
Subtask 36-11-00-710-106-A ** ON A/C NOT FOR ALL
Subtask 36-11-00-810-079-A ** ON A/C NOT FOR ALL
[Rev.8 from Aug 2018]
2026.04.04 04:33:43 UTC
Loss of the Two Sensing Elements of the Exchanger Outlet Temperature-Sensor of the Engine 1
1. Possible Causes
- SENSOR-EXCHANGER OUT TEMP, ENG 1 [6HA1]
wiring between pin A/1 of the exchanger outlet temperature-sensor (6HA1) and th ground terminal wiring from the exchanger outlet temperature-sensor (6HA1) to the BMC1 (1HA1) wiring from the exchanger outlet temperature-sensor (6HA1) to the BMC2 (1HA2) - BMC-1 [1HA1]
- BMC-2 [1HA2]
A. Referenced Information
| REFERENCE | DESIGNATION |
|---|---|
| ASM 361101 | |
| ASM 361102 | |
| AMM 36-11-17-000-001 | Removal of the Heat-Exchanger Outlet-Temperature Sensor |
| AMM 36-11-17-400-001 | Installation of the Heat-Exchanger Outlet-Temperature Sensor |
| AMM 36-11-34-000-001 | Removal of the BMC |
| AMM 36-11-34-400-001 | Installation of the BMC |
Subtask 36-11-00-710-106-A ** ON A/C NOT FOR ALL
A. Test.
(1) Not applicable, the fault is evident.
4. Fault Isolation(1) Not applicable, the fault is evident.
Subtask 36-11-00-810-079-A ** ON A/C NOT FOR ALL
A. If the fault symptom is identified by the maintenance message:
TEMP SENSOR 6HA1
Subtask 36-11-00-710-107-A ** ON A/C NOT FOR ALL TEMP SENSOR 6HA1
- replace the SENSOR-EXCHANGER OUT TEMP, ENG 1 [6HA1] AMM 36-11-17-000-001 and AMM 36-11-17-400-001.
- do a check for ground at pin A/1 of the exchanger outlet temperature-sensor (6HA1).
- do a check and repair the
wiring between pin A/1 of the exchanger outlet temperature-sensor (6HA1) and th ground terminal ASM 361101.
- do a check and repair the
wiring from the exchanger outlet temperature-sensor (6HA1) to the BMC1 (1HA1) , pins A/2 and A/4 to pins AA/9B and AA/10B - do a check and repair the
wiring from the exchanger outlet temperature-sensor (6HA1) to the BMC2 (1HA2) , pins A/4 and A/5 to pins AA/6D and AA/7D ASM 361102.
- replace the BMC-1 [1HA1] and/or the BMC-2 [1HA2] AMM 36-11-34-000-001 and AMM 36-11-34-400-001.
B. After the subsequent flight, make sure that the fault does not continue.