OXYGEN/TMR RESET P/BSW FAULT Legend Fault
TASK 35-23-00-810-803-A
OXYGEN/TMR RESET P/BSW FAULT Legend Fault
1. Possible Causes
A. Referenced Information
3. Fault Confirmation
Subtask 35-23-00-710-054-A 4. Fault Isolation
Subtask 35-23-00-810-053-A
Subtask 35-23-00-860-052-A
[Rev.8 from Aug 2018]
2026.04.04 04:33:38 UTC
OXYGEN/TMR RESET P/BSW FAULT Legend Fault
1. Possible Causes
PUSBUTTON SW-OXYGEN/TMR RESET (13WR) RELAY-SYS OFF (8WR) RELAY-SYS OFF (9WR) - wiring
RELAY-TIME DELAY (15WR)
A. Referenced Information
| REFERENCE | DESIGNATION |
|---|---|
| AMM 33-14-00-710-001 | Operational Test of the Lights |
| AMM 35-23-00-710-001 | Operational Check of Manual Mask Release |
| ASM 352301 |
Subtask 35-23-00-710-054-A 4. Fault Isolation
Subtask 35-23-00-810-053-A
A. If the FAULT legend on the pushbutton switch OXYGEN/TMR RESET, which is installed on the panel 50VU, comes on after approx. 30 seconds:
(a) Do a check and repair the wiring if necessary between:
Subtask 35-23-00-810-055-A - Do a check of the
PUSBUTTON SW-OXYGEN/TMR RESET (13WR) and replace it if necessary ASM 352301.
- Do a check of the
RELAY-SYS OFF (8WR) and replace it if necessary ASM 352301.
- Do a check of the
RELAY-SYS OFF (9WR) and replace it if necessary ASM 352301.
(a) Do a check and repair the wiring if necessary between:
- RELAY (6LP) connector A/17 and PB SW (13WR) connector A/7
- RELAY (6LP) connector A/33 and CB (1WR)
- RELAY (6LP) connector A/31 and GND
- RELAY (11WR) connector A/X1 and CB (7WR)
- RELAY (11WR) connector A/X2 and GND,
ASM 352301.
- Do the operational test of the annunciator light test system AMM 33-14-00-710-001.
- Do the trouble shooting procedure related to the maintenance message.
B. If the FAULT legend on the pushbutton switch OXYGEN/TMR RESET, which is installed on the panel 50VU, comes on and goes off after approx. 30 seconds:
(a) Do a check and repair the wiring if necessary between:
Subtask 35-23-00-810-056-A - Do a check of the
RELAY-TIME DELAY (15WR) and replace it if necessary ASM 352301.
(a) Do a check and repair the wiring if necessary between:
- RELAY (6LP) connector A/17 and PB SW (13WR) connector A/7
- RELAY (6LP) connector A/33 and CB (1WR)
- RELAY (6LP) connector A/31 and GND
- RELAY (15WR) connector A/X1 and CB (1WR)
- RELAY (15WR) connector A/X2 and GND,
ASM 352301.
- Do the operational test of the annunciator light test system AMM 33-14-00-710-001.
- Do the trouble shooting procedure related to the maintenance message.
C. If the FAULT legend on the pushbutton switch OXYGEN/TMR RESET, which is installed on the panel 50VU, comes on and goes off after pushing the OXYGEN/MASK MAN ON pushbutton switch:
(a) Do a check and repair the wiring if necessary between:
Subtask 35-23-00-710-055-A - Do a check of the
RELAY-TIME DELAY (15WR) and replace it if necessary ASM 352301.
(a) Do a check and repair the wiring if necessary between:
- RELAY (6LP) connector A/17 and PB SW (13WR) connector A/7
- RELAY (6LP) connector A/33 and CB (1WR)
- RELAY (6LP) connector A/31 and GND
- RELAY (15WR) connector A/X1 and CB (1WR)
- RELAY (15WR) connector A/X2 and GND,
ASM 352301.
- Do the operational test of the annunciator light test system AMM 33-14-00-710-001.
- Do the trouble shooting procedure related to the maintenance message.
D. Do the test as given in the Para. 3.A.
5. Close-upSubtask 35-23-00-860-052-A
A. Put the aircraft back to its initial configuration.