Inhibition of the Flap Condition not Possible

TASK 34-48-00-810-827-A
Inhibition of the Flap Condition not Possible

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
ESPM 2045110
ASM 344801

3. Fault Confirmation
Subtask 34-48-00-710-075-A

A. Test
Not applicable, you cannot confirm this fault on the ground.

4. Fault Isolation
Subtask 34-48-00-810-089-A

A. Do the procedure:

on the GPWS section of panel 21VU, make sure that the GPWS/FLAP MODE pushbutton switch (7WZ) is pushed (the OFF legend is on)
on the center pedestal, on the panel 114VU, put the flap and slat control lever in the 0 position
make sure that there is ground at pin AB/9C of the GPWC (1WZ).

(1) If there is no ground:

do a check of the wiring of the GPWS/FLAP MODE pushbutton switch (7WZ):
. pin A/B3 to the ground point
. pin A/B1 to GPWC (1WZ) pin AB/9C
ASM 344801.

(a) If there is no continuity:

(b) If there is continuity:

[Rev.8 from Aug 2018] 2026.04.04 04:33:16 UTC