DOC AIRBUS | TSM A320FFailure of the ADR2 Baro-Source Pin-Programming
TASK 34-13-00-810-979-A
Failure of the ADR2 Baro-Source Pin-Programming
1. Possible Causes
A. Referenced Information
3. Fault Confirmation
Subtask 34-13-00-740-319-A ** ON A/C NOT FOR ALL 4. Fault Isolation
Subtask 34-13-00-810-228-A ** ON A/C NOT FOR ALL
[Rev.8 from Aug 2018]
2026.04.04 04:32:32 UTC
Failure of the ADR2 Baro-Source Pin-Programming
1. Possible Causes
- ADIRU-2 [1FP2]
- aircraft wiring
- wiring BARO PORT A SELECT pin programming of the ADIRU2
A. Referenced Information
| REFERENCE | DESIGNATION |
|---|---|
| ASM 341202 | |
| AMM 34-12-34-000-001 | Removal of the ADIRU |
| AMM 34-12-34-400-001 | Installation of the ADIRU |
| AMM 34-13-00-740-002 | INTERFACE TEST of the ADR |
Subtask 34-13-00-740-319-A ** ON A/C NOT FOR ALL 4. Fault Isolation
Subtask 34-13-00-810-228-A ** ON A/C NOT FOR ALL
A. If the test gives the maintenance message WRG: BARO SOURCE SELECT PIN PROG:
Subtask 34-13-00-740-320-A ** ON A/C NOT FOR ALL - remove the ADIRU-2 [1FP2] AMM 34-12-34-000-001
- do a check of the wiring and make sure that there is a ground signal at pin AA/7G and an open circuit at pin AA/7F on the rack connector.
- repair the aircraft wiring : defective pin
- install the ADIRU2.
- do a check of pin AA/3C on the rack connector
- compare the state of the pin with the BARO PORT A SELECT pin programming given in the ASM ASM 341202.
- install a new ADIRU2 AMM 34-12-34-400-001.
- repair the wiring BARO PORT A SELECT pin programming of the ADIRU2 : pin AA/3C.
- install the ADIRU2.
B. Do the test given in Para. 3.