Failure of the CAPT (F/O) Static Probe
TASK 34-11-00-810-872-A
Failure of the CAPT (F/O) Static Probe
1. Possible Causes
2. Job Set-up Information
A. Referenced Information
3. Fault Confirmation
Subtask 34-11-00-740-148-B ** ON A/C NOT FOR ALL
Subtask 34-11-00-810-238-B ** ON A/C NOT FOR ALL
[Rev.8 from Aug 2018]
2026.04.04 04:32:17 UTC
Failure of the CAPT (F/O) Static Probe
1. Possible Causes
2. Job Set-up Information
A. Referenced Information
| REFERENCE | DESIGNATION |
|---|---|
| AMM 34-10-00-170-002 | Flushing of the Principal Static Pressure Lines |
Subtask 34-11-00-740-148-B ** ON A/C NOT FOR ALL
A. Test
Not applicable, you cannot confirm this fault on the ground.
4. Fault IsolationNot applicable, you cannot confirm this fault on the ground.
Subtask 34-11-00-810-238-B ** ON A/C NOT FOR ALL
A. If the Post Flight Report (PFR) gives: :
(1) The maintenance message R CAPT STATIC FAULT:
(a) Do a visual inspection of the R static probe 1 (8DA1):
(2) The maintenance message L CAPT STATIC FAULT:
(a) Do a visual inspection of the L static probe 1 (7DA1).
(3) The maintenance message R F/O STATIC FAULT:
(a) Do a visual inspection of the R static probe 2 (8DA2).
(4) The maintenance message L F/O STATIC FAULT:
(a) Do a visual inspection of the L static probe 2 (7DA2).
(1) The maintenance message R CAPT STATIC FAULT:
(a) Do a visual inspection of the R static probe 1 (8DA1):
- make sure that the static probe is not blocked (no obstruction),
- make sure that the pipe between the static probe and the ADM (19FP4) is in correct condition (not bent or crushed).
(2) The maintenance message L CAPT STATIC FAULT:
(a) Do a visual inspection of the L static probe 1 (7DA1).
- make sure that the static probe is not blocked (no obstruction),
- make sure that the pipe between the static probe and the ADM (19FP5) is in correct condition (not bent or crushed).
(3) The maintenance message R F/O STATIC FAULT:
(a) Do a visual inspection of the R static probe 2 (8DA2).
- make sure that the static probe is not blocked (no obstruction),
- make sure that the pipe between the static probe and the ADM (19FP6) is in correct condition (not bent or crushed).
(4) The maintenance message L F/O STATIC FAULT:
(a) Do a visual inspection of the L static probe 2 (7DA2).
- make sure that the static probe is not blocked (no obstruction),
- make sure that the pipe between the static probe and the ADM (19FP7) is in correct condition (not bent or crushed).