Failure of the Aisle Lights (Floor Proximity Emergency Escape Path Marking System) controlled by EPSU 13WL
TASK 33-51-00-810-842-A
Failure of the Aisle Lights (Floor Proximity Emergency Escape Path Marking System) controlled by EPSU 13WL
1. Possible Causes
A. Referenced Information
3. Fault Confirmation
Subtask 33-51-00-810-138-A
Subtask 33-51-00-860-098-A
[Rev.8 from Aug 2018]
2026.04.04 04:32:10 UTC
Failure of the Aisle Lights (Floor Proximity Emergency Escape Path Marking System) controlled by EPSU 13WL
1. Possible Causes
- LAMP MODULE (CLEAR) [361WL2]
- wiring
A. Referenced Information
| REFERENCE | DESIGNATION |
|---|---|
| AMM 33-51-00-710-001 | Operational Test of the Emergency Lights |
| AMM 33-51-00-710-007 | Operational Test of the Emergency Lighting in the Cabin with the 'LIGHT EMER' Pushbutton Switch |
| ASM 335104 | |
| AMM 33-51-19-000-001 | Removal of the Seat/Wall-Mounted Emergency Light |
| AMM 33-51-19-400-001 | Installation of the Seat/Wall-Mounted Emergency Light |
CAUTION:
DO NOT USE THE TEACH-IN PROCEDURE AS AN ALTERNATIVE FOR TROUBLESHOOTING. A TEACH-IN PROCEDURE IS NOT A RESET PROCEDURE. BEFORE YOU DO A TEACH-IN PROCEDURE, MAKE SURE THAT YOU CORRECTED ALL FAILURES. IF YOU DO NOT OBEY THIS, FAILURES CAN CAUSE A MALFUNCTION OF THE CABIN EMERGENCY LIGHTING SYSTEM.
Subtask 33-51-00-710-129-A 4. Fault IsolationSubtask 33-51-00-810-138-A
A. If the test gives a different maintenance message, do the trouble shooting procedure related to the maintenance message.
Subtask 33-51-00-810-139-A B. If the operational test gives the maintenance message:
(1) FPEEPMS AISLE LT/EPSU(13WL)AFT L:
Subtask 33-51-00-710-130-A (1) FPEEPMS AISLE LT/EPSU(13WL)AFT L:
- do the Operational Test of the Emergency Lighting in the Cabin by Pushbutton Switch AMM 33-51-00-710-007.
- during the test monitor the LAMP MODULE (CLEAR) [361WL2] on the related LH seat rows ASM 335104.
- replace the related LAMP MODULE (CLEAR) [361WL2] AMM 33-51-19-000-001 and AMM 33-51-19-400-001 if not illuminated ASM 335104.
- do a check and repair the wiring between:
the related lamp module 361WL2 pin 1 and EPSU 13WL pin -J.
the related lamp module 361WL2 pin 2 and GND ASM 335104.
C. Do the test given in Para. 3.
5. Close-upSubtask 33-51-00-860-098-A
A. Put the aircraft back to its initial configuration.